How does a Toyota OBDII readiness monitor work?
Toyota has various OBD2 readiness monitors for emissions testing, and by conducting a Toyota Drive cycle, you can activate and ready the Toyota ODBII sensors. If your smog technician tells you the specific drive cycle to perform, you can focus on just triggering that drive cycle.
Can a Toyota ODBII be used for OBD2 testing?
Toyota has various OBD2 readiness monitors for emissions testing, and by conducting a Toyota Drive cycle, you can activate and ready the Toyota ODBII sensors. If your smog technician tells you the specific drive cycle to perform, you can focus on just triggering that drive cycle. Otherwise you need to exercise each of the types of monitors.
How long does a Toyota OBD-II drive cycle take?
Drive the vehicle at a steady speed between 40-55 mph (64-88 km/h) or more for 7 minutes if IAT was below 50E F (10E C) at start-up, or 3 minutes if IAT was above 50E F (10E F) at start-up. Drive the vehicle at 35-45 mph (56-72 km/h) for 7 minutes. NOTES: Maintain smooth throttle inputs, avoiding sudden accelerations.
How to do an OBD scan on a Toyota?
Connect Scan tool in order to observe data stream and monitor status. Start the engine and allow it to idle 2 minutes. Drive the vehicle at a steady speed between 40-70 mph (64-112 km/h) or more for 3 minutes. Maintain engine speed between 900 & 3,200 rpm. Stop the vehicle and allow it to idle for ten (10) seconds or more.
When do you clear the OBD readiness monitor?
Remember, all on-board diagnostic monitors are cleared when the battery is disconnected, or when the power train control module (PCM) is cleared with a scan tool. Do not turn off the ignition switch during the test procedure. Allow the vehicle to run at idle until warmed up. Drive at a steady speed between 40 and 70 MPH for 10 minutes.
When does the readiness monitor complete on a Toyota Camry?
Although the drive cycle for a 2003 Toyota Camry might be slightly different, it’s worth giving it a try. As long as all the emission systems are working correctly, the readiness monitors should complete without setting a fault code (DTC) by the end of the drive cycle. 2004 Toyota Solara 2.4L 4 cyl engine. Drive Cycle for Evap, Catalyst ?