How much does it cost to replace a clutch kit?
The average cost for clutch replacement is between $1,202 and $1,375. Labor costs are estimated between $575 and $725 while parts are priced between $627 and $650. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
Is it hard to install a clutch kit?
After that, it’s about as straightforward as a job can be — basically just replace all of your wear parts: flywheel, pressure plate, clutch disc, pilot bearing and throw-out bearing. With new parts, you’ll want to reference a service manual for all of the proper torque figures.
How long should a clutch last on a car?
Most clutches are designed to last approximately 60,000 miles before they need to be replaced. Some may need replacing at 30,000 and some others can keep going well over 100,000 miles, but this is fairly uncommon.
What kind of clutch does a Toyota Corolla have?
To avoid this, cancel and sign in to YouTube on your computer. An error occurred. Please try again later. (Playback ID: sUpgT0O07Iv6fUqs) An error occurred while retrieving sharing information. Please try again later.
How many Toyota Corollas have been sold in the UK?
In July 2013, it reached a milestone by selling 40 million vehicles worldwide, so it will no doubt have made its presence felt in workshops throughout the UK. This helpful guide should, therefore, prove handy for any garage looking to undertake a clutch repair.
Where are the gear links on a Toyota Corolla?
Detach the gear linkage cables from the link arms held in by two clips. The clip for the first cable is on the top and the clip for the second cable is to the side (Fig 7). The cables are then held in place within the bracket by two retaining plates. These were a little tricky to remove but, with a little perseverance, they eventually come loose.
When to move on to the clutch relay?
Move on to the clutch relay if the fuse turns out fine. In a few car models, the power of the air conditioning system flows from the AC switch to the fuse before being transmitted to the clutch oil through the low-pressure evaporator temperature. You have to make sure that the compressor has enough oil to function properly.