Do I need to torque my oil drain plug?
you don’t have to be exact with torque 30-36 ft lbs would be fine with your drain plug. to keep things in perspective, if this is your first oil change on this car, then there would have been at least one oil changer that ran your drain plug down with an impact, and probably no one used a torque wrench.
How much should you tighten oil drain plug?
And for oil filters, we suggest tightening it as tight as you can get it by hand – so you turn it until it stops naturally, and then you might be able to twist it another quarter of a turn. And if you have to use a 12-inch breaker bar to get it off, then back off a little next time.
What is the torque on the Panamera oil drain plug?
Tighten the drain plug to 22 ft-lbs using a torque wrench.
Does an oil drain plug need a washer?
As far as the thread goes, yes, there should be a crush washer on the drain plug. Low pressure systems can sometimes get away without, but don’t ever try to re-use a crush washer on a brake system.
How do you change the oil on a Porsche Panamera?
Loosen the oil filter cover -1- with a suitable hexagon socket or ring wrench -2- and unscrew it.
- Slowly open the oil filter cover. Drain the remaining oil into a container.
- Remove the filter element.
- Clean the oil filter cover thoroughly inside and outside and replace the sealing ring.
How often should you replace oil drain plug?
Your drain plug should last the life of your engine if it is properly Torqued every time during oil change. I haven’t stripped a single drain plug in 20 years.
Can I reuse oil drain plug?
Always reused them in the past and never had a problem with doing so. On my Sentra it has a little copper crush seal on the drain plug. I went to the dealer and got a little bag of them for a couple bucks. Same plug, new seal each oil change.
What wrench do you need to change oil?
Use a properly fitting box wrench or a 6-point socket wrench to remove the plug. Be careful not to rock the socket to the side as this could damage the flats on the bolt.
What is the torque setting for our oil drain plug?
25 Nm (18.4 ft-lb) is the correct torque for both the Oil Drain Plug and Oil Filter Cap.
What size is the oil pan Drian plug?
Assuming you are looking for the oil drain plug, it is on the back side of the oil pan facing the rear of the vehicle. The oil pan is usually black in color and the oil plug is generally silver in color and about 17mm in size.
What size wrench do I need for the oil pan plug?
The oil pan drain plug should require a 14mm hex head wrench to remove. The transmission pan requires a 10mm allen head socket, or wrench to remove. Are you sure you’re trying to remove the correct drain?