How do you remove a radiator fan connector?
Lift the clip before pulling the male and female plug housings apart, if your plug is so equipped. Use the blade of a slotted screwdriver to lift the clip if you are unable to pull it up with a finger. The plug carries all electrical connections to the fan. Once it is unplugged, the fan power is disconnected.
Is the radiator fan connected to the AC?
In a nutshell: The radiator fan comes on so the A/C works at its highest efficiency. The A/C condenser (the part which sits in front of the coolant radiator) is a heat exchanger.
What is the radiator fan connected to?
A mechanical fan is connected to the engine directly by drive pulleys. This type of radiator fan is controlled by a thermal fan clutch that senses radiator heat. After sensing the heat temperature, the radiator fan turns on when the engine is running at a higher temperature.
How do you change the cooling fan on a Toyota Camry?
Disconnect the cooling fan connector. Connect battery and ammeter to the cooling fan connector. Check that the cooling fan rotates smoothly, and check the reading on the ammeter. Standard amperage: 8.0 to 12.0 A at 20 C (68 F) If not, replace the cooling fan.
Where is the ECT switch on a Toyota Camry?
Disconnect the ECT switch No. 1 connector. Connect the terminals on the ECT switch No. 1 connector. Check that the No. 1 cooling fan rotates at a high speed. If not, check the No. 1 cooling fan relay and No. 1 cooling fan. Reconnect the ECT switch No. 1 connector. Disconnect the ECT switch No. 2 connector.
How to disconnect electrical connections to a radiator fan?
Lift the clip before pulling the male and female plug housings apart, if your plug is so equipped. Use the blade of a slotted screwdriver to lift the clip if you are unable to pull it up with a finger. The plug carries all electrical connections to the fan. Once it is unplugged, the fan power is disconnected. Jonra Springs began writing in 1989.
How is a radiator fan connected to the hood?
The wiring to the fan is connected by a clip-secured plug. Remove the plug to release the electrical connections. Park the car and allow sufficient cooling time so you can safely touch metal parts under the hood.