Is the over head compass on a Toyota Tacoma?
My Tacoma didn’t come with the over head compass, so I picked the needed overhead console up at a nearby junkyard for $50. The existing compass in the console I bought from he junkyard was bad (no surprise) as the resistor and the circuit board was burned beyond repair.
How is the overhead temperature on a Toyota Tacoma?
This is how the overhead temperature and compass display unit is supposed to look in my 2006 Toyota Tacoma. Unfortunately, shortly after the warranty on the truck expired, so did the display.
What to do if your Toyota Tacoma pops off?
I recommend that you stop by (maybe call first) your local Toyota dealer and purchase 2 new clips because they do pop off occasionally and can migrate into the headliner. I’d also recommend using 2 hands to pull the unit down – one on each side of the front. That puts less torque on the plastic.
What is the part number on a Toyota Tacoma?
These are known for pre-mature failure. This is the NEW updated part from Toyota. This is just for the electrical meter, not the entire roof console box! Part number is 83290-04030. This was found in 2005-2008 Toyota Tacoma Sport edition trucks.
Where are the temperature resistors on a Toyota Tacoma?
There are two large surface-mount resistors on the lower right part of the board. They are labeled with the number 510. The problem is that these resistors get very hot during normal operation.
Where is the temperature and direction display located on a Toyota Tacoma?
This auction is for the display that illuminates the temperature and direction on the roof between your visors. These are known for pre-mature failure. This is the NEW updated part from Toyota. This is just for the electrical meter, not the entire roof console box! Part number is 83290-04030.
Do you need to calibrate the Toyota compass?
According to the Toyota technical bulletin, you’ll need to calibrate the compass. The procedure should be in your owner’s manual. Best of luck and it really is a piece of cake. Taking your time it ought to be now more than a 10 minute job ( unless you lose a clip and don’t have a spare).