How do you change a front right tire?

How do you change a front right tire?

How to Change Tires

1. Find a Safe Location. As soon as you realize you have a flat tire, do not abruptly brake or turn.
2. Turn on Your Hazard Lights.
3. Apply the Parking Brake.
4. Apply Wheel Wedges.
5. Remove the Hubcap or Wheel Cover.
6. Loosen the lug nuts.
7. Place the Jack Under the Vehicle.
8. Raise the Vehicle With the Jack.

How do you change a flat tire on a Toyota Corolla?

How-To Guide to Changing a Flat Tire

1. Pull Over and Park in a Safe Location.
2. Turn on Your Hazard Lights.
3. Apply the Parking Brake/Wheel Wedges.
4. Remove the Hubcap/Wheel Cover.
5. Loosen the Lug Nuts.
6. Raise Your Toyota with the Jack.
7. Unscrew the Lug Nuts.
8. Remove the Flat Tire.

What surface do you want when changing a flat tire?

The ideal place to position the jack when changing a flat tire is on a metallic surface close to the tire. Most vehicles with plastic molded underneath the body have a small gap that’s meant to accommodate the jack.

How do you fix a flat tire step by step?

Stuck with a flat tire? here’s How to Change a Tire in 10 steps

1. Find a Safe Place to Pull Over.
2. Check for Materials.
3. Loosen the Lug Nuts.
4. Lift Your Vehicle Off the Ground.
5. Remove the Lug Nuts and the Tire.
6. Place the Spare Tire on the Car.
7. Replace the Lug Nuts.
8. Lower Your Vehicle and Begin Tightening.

Where do you jack up a Toyota Corolla?

The Toyota Corolla has a series of notches below the front and rear doors on both sides. These are the designated lifting points. The jack needs to go into the notch nearest the wheel to be lifted.

Should car be in neutral when changing tires?

DON’T leave the car in neutral If the vehicle you’re changing a tyre on uses a manual gearbox, then it’s important that you don’t forget to leave it in the right gear. You’ll obviously want to leave the engine off before you start the tyre change, but the gearstick should be left in either first or reverse gear.

What causes a flat tire on a Toyota Corolla?

If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to

How to install wheel nuts on a Toyota Corolla?

• When installing the wheel nuts, be sure to install them with the tapered ends facing inward. 1 Remove the luggage floor cover. 2 Remove the tool tray. 3 Loosen the center fastener that secures the spare tire. CAUTION ■When storing the spare tire Be careful not to catch fingers

Where is the tire jack on a Toyota Corolla?

4 Turn the tire jack portion “A” by hand until the notch of the jack is in contact with the jack point. The jack point guides are located under the rocker panel. They indicate the jack point positions.

When to place a tire on the ground?

When resting the tire on the ground, place the tire so that the wheel design faces up to avoid scratching the wheel surface. ●Do not touch the disc wheels or the area around the brakes immediately after the vehicle has been driven. After the vehicle has been driven the disc wheels and the area around the brakes will be extremely hot.