Where is the fuel safety switch located?
Look for the fuel pump switch or inertia switch. This is a small box with a plastic button on top and an electrical connector at the bottom. On some vehicle models, this will be located in the luggage compartment. Look on a side panel for a small, round button which you can pry off with a small screwdriver.
Where is the fuel relay switch located on a 2006 PT Cruiser?
Re: fuel pump relay Easy on the 01-05 cruisers but difficult on the 06+. According to RockAuto where a lot of us get our parts this is a fuel pump relay for a 2006 PT Cruiser….. Now all you have to do is find it. There are some relays on the firewall of your cruiser on the drivers side right below the windshield.
How do I reset my fuel safety switch?
RESETTING THE SWITCH
- Turn the ignition switch OFF.
- Ensure that there is no fuel leaking in the engine compartment, along any of the lines or at the tank.
- If no leakage and/or odor is apparent, reset the switch by pushing the reset button on the top of the switch.
Why would my 2006 PT Cruiser shut off while driving?
Out of Fuel Your engine needs three things to run properly; air, fuel, and spark. If your engine is running fine and then it just suddenly dies, one of these three things was abruptly taken away. It’s usually fuel. The most common reason that a vehicle shuts off when driving is a lack of fuel.
Where is the horn fuse located on a 2006 PT Cruiser?
Where is the horn relay on a 2006 PT Cruiser? The Horn Relay is “built in” to the TIPM (Totally Integrated Power Module) which is located under the hood (which is the main Fuse / Relay Panel.
Where is the fuse panel on a 2006 PT Cruiser?
Fuses and relay Pt Cruiser The fuse access panel is on the left side of the instrument panel next to the steering column.
What would cause a PT Cruiser not to start?
While there are a variety of reasons your Chrysler PT Cruiser won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.
What goes wrong with PT Cruisers?
Top Chrysler PT Cruiser Problems
- Multifunction Turn Signal Switch May Fail.
- Locked up WCM may cause engine cranking problems.
- Recall to reposition high pressure power steering hose.
- Software Updates for Powertrain Control Module Will Improve Shift Quality.