How do you remove the gas tank from a 2002 Ford Explorer?
Fuel Tank Removal
- Disconnect the negative battery cable with an 8 mm wrench.
- Remove the fuel filter located on the passenger’s side frame rail.
- Raise the vehicle with a car jack and support it on jack stands.
- Disconnect the fuel filler hose from the fuel filler intermediate tube with the screwdriver.
Where is the fuel filter on a 2001 Dodge Ram?
The 2001 Dodge Ram 1500 fuel filter location is inside the fuel tank. Car parts will someday become ineffective at some point. The fuel filter needs to be replaced every 30,000 miles.
Do you have to remove the fuel tank to replace the fuel pump?
Replacing your fuel pump isn’t as hard as you might imagine. In most, you must drop the fuel tank, and first drain most gas if needed. Some vehicles have an access panel in the body to get to the top of the tank to remove the assembly without dropping the tank.
What should the oxygen level be in a fuel tank?
Entry and Exiting a Fuel Tank. Entry and Exiting a Fuel Tank Never enter a tank without a portable gas detectors are used to monitor the oxygen and flammable vapor concentrations within the fuel tanks. Oxygen concentrations should be between 19.5 and 23.5 percent.
What are the dangers of fuel tank entry?
The most commonly recognized hazard of fuel-tank work is the jet fuel itself. Jet fuel is a flammable liquid and can be ignited given certain ambient conditions, primarily temperature and vapor concentration. The temperature at which the vapors of a flammable liquid can ignite is known as the “flash point.”.
How big is the hole in an airplane fuel tank?
The physical characteristics of the tank itself can create hazards and can also exacerbate fire, explosion, and toxicity hazards. Entry into most airplane fuel tanks is through an oblong hole less than (0.6 m) long and (0.3 m) wide.
How to test for fuel injector or fuel rail leak?
(12) Testing for fuel injector or fuel rail leak- age: Clamp off the rubber hose portion of Adaptor Tool between the fuel rail and the test port âTâ on Adapter Tool. If pressure now holds at or above 30 psi, a fuel injector or the fuel rail is leaking.