How to install camshaft timing gear on Toyota Camry?
INSTALL CAMSHAFT TIMING GEAR ASSY Put the camshaft timing gear and the camshaft together with the straight pin and key groove. Turn the camshaft timing gear (as shown in the illustration) while pushing it lightly against the camshaft. Push further at the position where the pin gets into the groove.
Can a bad camshaft sensor shut down an engine?
Without this information, the engine would not be able to function properly. Over time, the camshaft position sensor can fail, or become worn down, due to accidents or normal wear and tear. There are a few warning signs to watch out for before your camshaft position sensor completely fails and shuts down the engine, making replacement a necessity.
How much torque does a Toyota Camry have?
Torque: 30 N·m (301 kgf·cm, 22 ft·lbf) for bearing cap No. 1 9.0 N·m (92 kgf·cm, 80 in.·lbf) for bearing cap No. 3 16. INSTALL No.2 CAMSHAFT a. Put the camshaft on the cylinder head with the painted mark of the link of chain aligned with the timing mark of the camshaft timing sprocket. b. Raising the camshaft, temporarily tighten the sprocket bolt.
How do you remove a No.2 camshaft?
Raise the No. 2 camahaft and remove it. Then remove the sprocket bolt. Remove the timing chain sprocket and the timing chain from the No. 2 camshaft. Remove the camshaft timing sprocket from the timing chain. 12. REMOVE CAMSHAFT Uniformly loosen and remove the camshaft’s 10 bearing cap bolts in the sequence shown in the illustration.
How do you remove camshaft from Toyota Camry?
Uniformly loosen and remove the No. 2 camshaft’s 10 bearing cap bolts in the sequence shown in the illustration. Then remove the 5 bearing caps. Raise the No. 2 camahaft and remove it. Then remove the sprocket bolt. Remove the timing chain sprocket and the timing chain from the No. 2 camshaft.
Why does my transmission make a noise when I change gears?
Transmission Makes a Noise When I Step on the Clutch Pedal If the noise happens only when you depress the clutch pedal to change gears, the noise is probably coming from the release bearing in the clutch assembly, not the transmission itself. 3. Transmission Makes a Noise When I Let Off the Clutch Pedal
Where is timing mark 0 on Toyota Camry?
SET No. 1 CYLINDER TO TDC/COMPRESSION Turn the crankshaft pulley, and align its groove with the timing mark 0 of the timing chain cover. Check that the timing marks of the camshaft timing gear and camshaft timing sprocket are aligned with the timing marks of the bearing cap as shown in the illustration.
Is the timing belt on a Camry 3mzfe interchangeable?
Most engine components in the 1MZFE are interchangeable with the 3MZFE, including the timing belt, tensioner pulley, and guide pulley, although the 3MZFE has a different tensioner configuration. See my other article for replacement of a timing belt on the four-cylinder Camry (the 5SFE engine).
Why does the camshaft turn to the advanced angle?
HINT: The camshaft timing gear will turn to the advanced angle side without applying foce by hand depending on the force of the air pressure applied. Also, if applying pressure to the oil path is difficult as a result of air leakage from the port, the lock−pin may be difficult to release. e. Remove the fringe bolt from the camshaft timing gear.
What happens when the camshaft position sensor does not work?
3. Vehicle will not start The camshaft position sensor gathers information about the vehicle’s camshaft speed and sends it to the vehicle’s engine control module (ECM). The ECM uses this data to determine the timing of the ignition, as well as the timing of the fuel injection that the engine requires.