How to make a good wiring diagram for a heater?
If good so far then pull the middle & bottom wires, make sure the black one has continuity to ground & touch them together & with the key on try all 4 speeds at the speed switch. If good that way the mode switch is bad.
How to draw a wiring diagram for a jeep heater?
Since you did have melting at the mode switch, a common problem, & replaced the connector with 3 individual wires make sure the wires are in the correct positions. Smaller light green wire on top, larger dark green wire in the middle & black on the bottom.
Can you print out an electrical wiring diagram?
Print the electrical wiring diagram off plus use highlighters to trace the circuit. When you make use of your finger or even follow the circuit together with your eyes, it may be easy to mistrace the circuit. One trick that I use is to print out a similar wiring diagram off twice.
Is the circuit of an electric water heater the same?
All circuits are usually the same ~ voltage, ground, single component, and switches. Wiring An Electric Water Heater Diagram Source: i.ytimg.com Wiring An Electric Water Heater Diagram Source: lh4.googleusercontent.com
How does the motor connect to the heater?
When the relay closes which should be when the key is on then power is sent to the motor from fuse 1 in the PDC. The motor gets grounded as described in the link I gave with the last step being through the mode switch. You haven’t said what exactly the problem is but I’m assuming you have no blower on any speed.
Where does the power go to the blower relay?
All of this assumes you have power to the blower motor. The panel does not power the relay. Fuse 8 behind the glove box does that. When the relay closes which should be when the key is on then power is sent to the motor from fuse 1 in the PDC. The motor gets grounded as described in the link I gave with the last step being through the mode switch.