Why are the lights not working on my coach?
Sounds like a possible transfer switch or fuse issue. With the 12 volt lights working when on shore power means the charger is working. Look for a large fuse between the batteries and the charger 12 volt output feed to the positive coach battery terminal (s). With a meter you should read a voltage at the positive terminals.
Why do my lights not come on when not connected to shore power?
With 12 volts present when the charger is running when on shore power, one would suspect there is a wire routing issue, as you should get 12 volts from both the charger and or the batteries if things are connected properly. I have a feeling that you do not have 110 volts from the inverter output when you are not connected to shore power.
How to tell if your car has no power?
I have no electrical, wont turn over, no lights. If I put on the hazard I can hear the relay click but no lights. The parking brake light on the dash lights up but VERY faint. -New battery…nothing, still worn turn over, no power.
What are the fuses for the dash lights?
Pretty sure if you check your fuse box there are some fuses one black a couple yellows the black fuses for a temporary parking so that there’s no drain on your battery underneath that black cover is the fuse that controls your dash lights in the clock check that one and that should probably clear it up
I have no electrical, wont turn over, no lights. If I put on the hazard I can hear the relay click but no lights. The parking brake light on the dash lights up but VERY faint. -New battery…nothing, still worn turn over, no power.
Pretty sure if you check your fuse box there are some fuses one black a couple yellows the black fuses for a temporary parking so that there’s no drain on your battery underneath that black cover is the fuse that controls your dash lights in the clock check that one and that should probably clear it up
What to do if your Jeep wont start with no power?
Got one one day ,then went to go to work the next morning and BAM it’s as if his battery was drained. Lights came on very faint and all we got was small clicks. New key ignition unit and the thing worked perfectly again. Also, your Jeep will not start if you have no power going to anything.
How can I tell if my ignition switch is bad?
Wires come loose, have a helper attempt to start the engine while you wiggle the wiring connectors. Check also for damage, water or scorch marks on the panel itself. Ignition switches are an important part of the ignition system, bad connections here can cause lots of problems. Ignition switches – send commands to the control module if fitted.