How do you clear the indicator light?
How to Reset the Warning Lights on the Dash
- Open the hood of your vehicle.
- Loosen the nut that holds the negative terminal to the battery with the pliers.
- Completely remove the cable from the negative battery terminal.
- Leave the battery disconnected for 10 minutes to ensure that the computer is fully reset.
Why is my BSM light on?
The available Blind Spot Monitor (BSM) switch illuminates when the system is turned on. This light indicates a malfunction in the Blind Spot Monitor system. Have the vehicle inspected by your Toyota dealer immediately.
Why is my service light still on?
The service required light is mainly used to remind drivers when it is time to change the oil and filter, but could be used for other fluids or components. In the past, this light was similar to the check engine light and could mean that a fault has been detected by the system.
What does the Check Engine light mean on a Toyota?
Commonly known as the ‘check engine’ light, when this warning light is illuminated it’s often accompanied by tell-tale signs that the engine is not working properly, such as a lack of power or stuttering as you press the accelerator.
When does the indicator light stop flashing on a Toyota?
The indicator light stops flashing after the ENGINE START STOP switch has been turned to ACCESSORY or IGNITION ON mode to indicate that the system has been canceled. The indicator light flashes after the key has been removed from the engine switch to indicate that the system is operating.
What does the red warning light mean on a Toyota?
When you engage the system by pressing the switch, this red warning light will come on to remind you that the lock has been activated and you should keep your speed below 5 mph. When you switch off the system the light should go off. If you have a 4WD Toyota]
What does it mean when the Traction Light comes on in a Toyota?
If it’s flashing it means the traction system is intervening – for example, if you’re driving on a slippery road. Slow down and allow your car to regain traction. If the light stays on it means the system is deactivated. You may have inadvertently turned off the traction system. To check, try stopping and restarting the engine.