How do I completely drain my coolant system?
- STEP 1 – Safety first.
- STEP 2 – Press down on the radiator cap, slowly turn it counter-clockwise until it hisses, wait until the.
- STEP 3 – Place a large container under the drain valve at the bottom of the radiator.
- STEP 4 – Loosen the drain valve and allow the coolant to completely drain out.
What happens if I get water in my engine?
Do not try to start the car again – If water gets into the engine, transmission or fuel system, it’ll only make the problem worse. Water can destroy internal engine parts and cause ‘hydrolock’, when the pistons fail to compress and move as they should.
Where is the coolant drain plug on a Toyota?
It is located under the exhaust manifold near the front of the engine. Look for the 10mm bolt with a small tube next to it. The service manual is completely misleading about the location. I am going to try draining the radiator, then open the engine drain plug to see if I get any more coolant out. I’m curious to see if it makes a difference.
How to change coolant in Toyota Corolla 1.8L?
I am going to change the coolant in my 2009 corolla 1.8L. The service manual instructions tell me to open the “cylinder block drain cock plug” and I can’t find it.
Where is the coolant reservoir in a Toyota Corolla?
The video above shows you where the coolant reservoir in your Corolla is located and how to add coolant. Be sure to check your owners manual to determine the correct type of fluid to add – for Toyotas, it will typically be in a section titled Fluid Capacities in the back of your manual.
How to drain and fill a Toyota 4Runner?
Use Code DIYDISCOUNT. 2001 Toyota 4Runner. My friend had her car inspected at a Toyota Dealer in Henderson, Nevada. One of the recommendations was to drain and fill the radiator and engine block. She had not changed her coolant fluid since 2-3 years ago when she had her timing belt and water pump replaced at the dealer.