How much does it cost to replace brakes on a PT Cruiser?
Chrysler PT Cruiser Brake Pad Replacement Cost Estimate. The average cost for a Chrysler PT Cruiser brake pad replacement is between $246 and $260. Labor costs are estimated between $53 and $67 while parts are priced at $193. This range is based on the number and age of Chrysler PT Cruiser’s on the road.
Do PT Cruisers have drum brakes?
Chrysler PT Cruiser Drum Brake System.
How long does it take to change brakes by yourself?
But exactly how long does it take to replace brakes and rotors? Due to the fact that various components that make up the brake system are subject to wear and tear, they will need to be replaced. This process can take expert mechanics anywhere from thirty minutes to one hour.
How much does it cost to have your brake pads changed?
The average brake pad replacement cost is $150 per axle, and can range from $100 per axle up to $300 per axle. There are a few other pieces of hardware that are found in the brake system which might need to be serviced as well, including calipers and rotors, but the most common service will be to replace brake pads.
How much do new rotors and brake pads cost?
How much should it be to replace the brake pads and rotors? Expect a brake job of replacing brake pads and rotors to cost $250-$400 per axle on average.
What causes the parking brake to fail on a PT Cruiser?
Road grime can build up inside, causing the parking brake to fail. Put wheel chocks in front of and behind the front wheels of the Cruiser. Lift up the rear of the Cruiser with a jack and lower it onto two jack stands. Loosen the lug nuts on the rear wheels with a lug wrench. Remove the lug nuts and the wheels.
Where are the emergency brake shoes located on a PT Cruiser?
The emergency brake shoes on the Chrysler PT Cruiser are located in the middle of the rear disc brake rotors. While you are adjusting the emergency brake shoes, you should also clean them to ensure that the emergency brake functions properly.
How do you remove a brake rotor from a car?
Hold the caliper up using a bungee cord attached to the rear strut. Remove the wheel stud clips and throw away. Remove the rotor from the hub. Repeat steps 4 through 6 for the other side. Position a pan under the brake assembly. Spray the brake shoes and the area with brake cleaner. Wipe off with a clean rag. Repeat for the other wheel.