How to reset timing belt on Toyota Landcruiser?
This is tutorial on how to reset timing belt on Toyota Dyna / Toyota Landcruiser (Same procedure for both). 1. T-BELT MODE DISPLAY b) While pressing the trip switch, turn the ignition switch ON and hold it for 5 seconds. c) Release the trip switch, then press the switch again within 5 seconds. d) The digital display should change to T-belt mode.
How to reset the timing belt warning indicator?
Timing Belt Warning Indicator Reset Procedure. For LandCruiser UZJ100, HZJ105 and HDJ100. a) With ignition turned ON, using the trip switch (select/reset button) change the display to ODO, and turn the ignition OFF. b) While pressing the trip switch, turn the ignition switch ON and hold it for 5 seconds.
How to turn off the T Belt Light on a Toyota Land Cruiser J200?
To turning off the T-belt Light on 2008, 2009, 2010, 2011, 2013, 2014, 2015 Toyota Landcruiser J200, conform to the following instructions: Turn the ignition switch to the “On” position, but do not start the engine. If your car has START push-button, press the “Start” without touching the brake pedal. Press the odometer button until you see “ODO”.
How does the reset button work on a Land Cruiser?
The worm drive passes over a small black box that has electrical connections to the reset button. So, the black box must have a cog attached to the worm drive (can’t see it) and the box counts six increments of the 10,000 mile digit and then triggers the light. The reset button tells it to stop counting and start again.
How to reset timing belt on Toyota Dyna?
Toyota Dyna /Landcrusier T-belt light reset – YouTube This is tutorial on how to reset timing belt on Toyota Dyna / Toyota Landcruiser (Same procedure for both).1. T-BELT MODE DISPLAYa) With ignition turned ON,
Can you drive a Toyota Coaster on a car licence?
The main ones we want to focus on for a Toyota Coaster are Class C (Car) and LR (Light Rigid). However, MR (Medium Rigid) and HR (Heavy Rigid) may be relevant if you are looking at a larger bus for your conversion. C (Car): Vehicles up to 4.5 tonne Gross Vehicle Mass (GVM).
How to reset the T Belt warning light?
T-BELT WARNING RESET COMPLETION a) After setting the replacement setting value, hold the trip switch ON for more than 5 seconds then release the switch. b) Check that the display has now changed back to ODO and that the warning light has gone off when the engine is started.