Why is the reverse light not working on my Subaru Outback?
(The rubber boot is in good condition and all wires appear to be in good shape as well). Any ideas? Check the reverse light switch they can go open circuit when they are supposed to be closed. Just check with a multimeter or test light. — If I am getting a low current rating of 7V, it probably suggests the reverse switch is bad.
What to do if your backup light is not working?
With the parking brake set, transmission in Park, ignition OFF, measure the resistance (continuity) between the fuse panel blade receptacle that had no Voltage and a good ground. There should be no continuity (i.e. it should be a very high resistance). Then change the transmission to Reverse (ignition switch at OFF or ACC).
Where are the fuses on a Subaru Outback?
The fuses in the dash fuse panel (such as #18) have small openings above their pins. It’s possible to check for voltage at both sides of the fuse using a fine test probe (or pin), just to be sure power is getting through. Also, the diagram of the fuse layout can be confusing. On my car, it’s reversed from the actual fuse panel arrangement.
Where is the break on the backup light?
In some cases the break is not at the visible end of the boot but just slightly up into it where the wires are bundled more tightly.
When does a Subaru all wheel drive system fail?
The system needs to allow slip in the clutch when the front and rear tires are rotating at different speeds. This is usually only on turns. When the duty solenoid fails it usually will turn on the AT Oil Temp lite. To retrieve codes for the TCM on older models without a Subaru scanner is a tricky procedure but not that bad once you know it.
Where is the inhibitor switch on a Subaru Outback?
There’s a mechanical cable between the gear selector lever (underneath) and the switch that moves the inhibitor switch (and some internal transmission linkages) through the various positions as the lever is moved.
Can a Subaru Outback have all wheel drive?
Yes the abs wheel speed sensors are monitored on certain models to differentiate front to rear wheel speed differences. AWD will only be fully engaged while driving forward in straight line. 2004 outback h6 automatic. Makes bearing noise only in awd during decelerating. If I put the car in fwd no noise.