Why is my cruise control flashing on my Subaru Outback?
Subaru Outback Questions – Flashing brake, traction control, cruise control, and check engine lig… – CarGurus dashboard. After driving for about 45 minutes on the highway, I noticed that control light was on, and the cruise control were all flashing. My car has no obvious changes in performance, so I am puzzled as to why this happened.
How to clear flashing brake and traction control code?
Also if you do not have a scan tool you can just wait till you cycle the ignition switch 6 times and it will clear the code if it is not a hard code meaning that you have a real problem not just a temporary fault. 5 people found this helpful. A bit ambiguous above….
What does a flashing brake warning light mean?
A flashing Brake warning light indicates a fault detected by the on-board diagnostics as opposed to something like low brake fluid (in which case the light is on steady). One possibility is a malfunction in the electronic parking brake system.
What kind of traction control does a Subaru Outback have?
2011 2.5 Outback. 138k miles (all are mine). Had the 100,000 mile transmission service done at dealer. Had timing chain done as well. I have the traction control, Cruise flash, AT oil temp and CEL. Had the codes pulled at auto part store. Came back with Transmission/torque converter codes P0700 and P2763.
Subaru Outback Questions – Flashing brake, traction control, cruise control, and check engine lig… – CarGurus dashboard. After driving for about 45 minutes on the highway, I noticed that control light was on, and the cruise control were all flashing. My car has no obvious changes in performance, so I am puzzled as to why this happened.
Why is the traction light blinking on my Subaru Forester?
Left the Service center and went about 7 miles and the traction light, service engine light came on and the cruise control light started blinking. Returned to Service center and they found an error code for a faulty catalytic converter.
What does check engine light mean on Subaru Outback?
While driving down the highway in my 2011 Outback, my ‘check engine’ light suddenly went on, the ‘brake’ light flashed, another light came on indicating a car sliding, another light that was a picture of a headlight, my remote was disabled, and my Nav system went on and off. My Subaru dealer couldn’t take me for 3 weeks.
Also if you do not have a scan tool you can just wait till you cycle the ignition switch 6 times and it will clear the code if it is not a hard code meaning that you have a real problem not just a temporary fault. 5 people found this helpful. A bit ambiguous above….
Is the brake light blinking ON MY 2012 Outback?
My 2012 Outback 2.5i Premium had the CEL, CC flashing, brake light blinking, etc. with only 316 miles on the odometer. It occured on a Saturday afternoon during its first road trip. After pulling off onto the shoulder, I checked the fluid levels and the gas cap. My wife also checked the gas cap and then I checked it again.
2011 2.5 Outback. 138k miles (all are mine). Had the 100,000 mile transmission service done at dealer. Had timing chain done as well. I have the traction control, Cruise flash, AT oil temp and CEL. Had the codes pulled at auto part store. Came back with Transmission/torque converter codes P0700 and P2763.