Where does the spark come from on a dirt bike?
One feeds the CDI a 15-25 volt AC charge and the other a much smaller millivolt AC charge in the range of 5 to 25 millivolts which is the trigger charge for the CDI. The trigger charge indicates the engine rpm to the CDI which then determines the best time to discharge the ignition capacitor.
Where is the spark plug on an ATV?
To locate the ignition coil, simply follow the wire connecting to your spark plug. Once you have the ignition coil out, you can hook your multi-meter up to it to begin testing. Start by testing the primary side of the ignition coil, where the ignition coil was wired, not the side that goes to the spark plug.
Where does my spark come from-coil come from?
The primary side of the coil is basically small coil of wire. When the charge flows through the wire in the primary side of the coil it produces a magnet field.
What happens when there is no spark from the ignition coil?
1 Power. Two positions of the ignition switch provide power to the positive primary post of the ignition coil. 2 Signal. With no external signal to the coil negative primary post, voltage would travel through the ignition coil windings without inducing any secondary spark. 3 Flow. 4 Open Circuits. …
What to do if your dirt bike has no spark?
To fix a dirt bike with no spark, you must remove the spark plug from the cylinder block, put it back in the ignition coil, and kick start the bike to check for the spark. If there is no spark, replace the plug with a new one and double-check all the electric components and repeat the process.
What should I do if there is no spark on my coil?
Remove the black wire that plugs to your coil and try checking your spark with this wire unattached. This is your kill wire. ok what should happen once disconnected? This wire will eliminate the possibility of a safety switch or a bare wire preventing your coil from producing a spark.
What does a blue spark mean on a dirt bike?
The very first place to start is your spark plugs. To test your spark plugs: Remove plugs from the cylinder head. Plug them into the plug cap. Holding the plug up to the head bolt, turn over the engine. A yellow or blue spark bridging the gap signifies that the spark is strong enough to ignite the cylinder’s fuel/air mixture.
How do you get a spark out of an ATV?
Remove the ignition coil lead boot from the spark plug. Pull straight outwards from the engine. Remove the spark plug from the engine. Use a spark plug socket wrench. Spark plugs sockets are either 5/8 inches (16mm) or 13/16 (21mm) inches. Connect the spark plug with the ignition coil lead.