How big are the spark plugs on a Chrysler?
Select your preferred location and we’ll note which parts are ready to be picked up TODAY. Spark Plug, Shorty, C-Cut Electrode, Gasket Seat, 14mm Thread .750 in. Reach, Projected, Resistor, Set of 4
What was the gear ratio on a 1976 Dodge Charger?
Model year 1976 Dodge passenger cars, such as the Charger, matched the 360 with the three-speed automatic. The standard rear gear ratio on all 1976 Chrysler products equipped with the 360 was 2.71. Optional gear ratios matching the 360 were 2.45, 2.94, the 2.71 Sure Grip and the 3.21 Sure Grip. The 360 was the base engine for the 1970s Chargers.
How much torque does a big block Mopar have?
Mopar Bolt Torque Specifications – Big Block Bolts or Parts Torque to: Main Caps 85 ft-lbs. Connecting Rod Bolts (Plain) 45 ft-lbs. Connecting Rod Bolts (Heavy Duty) 55 ft-lbs. Crankshaft Rear Bearing Seal 30 ft-lbs.
How much torque do you need to reinstall a spark plug?
For reinstalled plugs with a used gasket only a ¼ turn is required for gas tight seal for both cast iron and aluminum cylinder heads. Note: If using a torque wrench, please refer to the Torque Recommendations chart below. *Torque recommendations are for new gaskets.
Model year 1976 Dodge passenger cars, such as the Charger, matched the 360 with the three-speed automatic. The standard rear gear ratio on all 1976 Chrysler products equipped with the 360 was 2.71. Optional gear ratios matching the 360 were 2.45, 2.94, the 2.71 Sure Grip and the 3.21 Sure Grip. The 360 was the base engine for the 1970s Chargers.
What was the purpose of the Dodge Slant 6 engine?
This allowed the engine to produce a very large amount of torque which caused it to spread far beyond the use of the average automobile. It is similar to the Ford 300 inline 6 in the sense that it was not only used in cars and trucks but also in a vast array of farm tractors, forklifts and even boats.
How much torque does a Dodge 360 have?
Its torque was 360 ft.-lbs. at 2,400 rpm. Torque provides the acceleration for the vehicle. The 360’s normal oil pressure range was identical to its siblings at 45 to 65 psi. The 360’s closet rival in raw power was the 383, which had a larger cylinder bore at 4.35 inches, but a shorter stroke at 3.38 inches.
What kind of wiring does a Dodge truck have?
The wiring harnesses for computerized and non computerized trucks are totally different. 1985 and newer 4WD trucks had an added wire going to the vacuum controlled front hubs.