Where is the spark plug on AMC 304?
If you stand if front of the engine, facing the drive belts, the number one plug wire will be the first one on your right side. Make sure the clamp-on clip is as close to the spark plug as possible.
Where do you connect the spark plug wire?
The cylinders are numbered and oriented differently depending on the make of the vehicle. Connect a spark plug wire between the number one cylinder and the distributor’s number one terminal.
Where do I get the ignition coil for a jeep 304?
If you ask for the components from an engine WITH ECC (Electronic Combustion Control) you will get the square TFI (Thick Film Integrated) ignition coil, and the plug wire set with the correct coil wire. You will have to remove (cut) the stock coil connector from the wiring harness in order to connect the TFI coil.
How to put spark plug wires in the correct firing order?
Compare the spark plug wires to the manual’s firing order and make sure each wire is attached to the correct distributor terminal. If engine backfires or runs rough, turn off engine and verify the wires are connected correctly.
The cylinders are numbered and oriented differently depending on the make of the vehicle. Connect a spark plug wire between the number one cylinder and the distributor’s number one terminal.
If you stand if front of the engine, facing the drive belts, the number one plug wire will be the first one on your right side. Make sure the clamp-on clip is as close to the spark plug as possible.
Compare the spark plug wires to the manual’s firing order and make sure each wire is attached to the correct distributor terminal. If engine backfires or runs rough, turn off engine and verify the wires are connected correctly.
How to crimp spark plug wire and install boots?
Strip the outer silicone layer, leaving about ¾-inch to 1-inch of conductor wire visible. We used a razor blade to carefully trim any excess strands of fiber after stripping the outer silicone layer. Slide the terminal in place with the conductor wire folded over and positioned inside the saddle.