When to replace power steering belt in Toyota?
In the Toyota V6 engines, they drive the alternator and A/C compressor on one belt, and the power steering pump on the secondary belt. Replacing the belts is a good idea if they are worn, cracked or are squealing on cold starts. Belt failure can lead to sudden loss of steering, a discharged battery or an ineffective A/C system.
What’s the difference between an alternator and a power steering belt?
The alternator belt uses a pinch bolt and a long tension bolt, in addition to its pivot bolt. The power steering bolt has a tension bolt and a pinch bolt that slides on a track. Tensioning the power steering belt can be difficult since the position of the pump, determined by the position if your pry bar, determines the tension.
What does the serpentine belt on a Toyota do?
Toyota or Lexus with a V6 engine. The serpentine belts are responsible for driving accessories off of the crank of the engine. In the Toyota V6 engines, they drive the alternator and A/C compressor on one belt, and the power steering pump on the secondary belt.
How to check the tension on a power steering belt?
To check the tension, lay a straight-edge along the outer edge of the belt. If the belt goes round more than two pulleys, use the longest run of the belt. Use your thumbs to push the belt inwards at its mid point, pushing quite hard.
How do I loosen the belt on a power steering pump?
Loosen the pivot bolt on the side of the power steering pump and the lock bolt holding the pump to the bracket with a socket wrench. Pivot the pump toward the engine to create slack in the belt. Slip the belt off the crankshaft pulley and power steering pump pulley. Guide the new belt over the crankshaft pulley and power steering pump pulley.
Where is the power steering drive belt located?
Install the power steering drive belt over the top of the power steering pulley. Route the drive belt down and under the crankcase pulley. The crank pulley is the large pulley located on the bottom center of the engine. Pull the power steering pump away from the engine, using a small pry bar for leverage.
What to do if your power steering belt is too slack?
If the belt was too slack, increase the tension by levering the pump outwards with a strong screwdriver or flat bar. Lever against the cast front end of the pump body, just behind the drive-belt pulley — not against any other part of the body or pipework, which are easily damaged.
In the Toyota V6 engines, they drive the alternator and A/C compressor on one belt, and the power steering pump on the secondary belt. Replacing the belts is a good idea if they are worn, cracked or are squealing on cold starts. Belt failure can lead to sudden loss of steering, a discharged battery or an ineffective A/C system.
Where can I buy a belt for my Camry?
Shop AutoZone for Toyota Camry Belt. 10% OFF $75. Use Code: DIYSAVE10 Online Ship-to-Home Orders Only
The alternator belt uses a pinch bolt and a long tension bolt, in addition to its pivot bolt. The power steering bolt has a tension bolt and a pinch bolt that slides on a track. Tensioning the power steering belt can be difficult since the position of the pump, determined by the position if your pry bar, determines the tension.
What are the names of the pulleys on a Toyota?
Other Names: Idler Pulley, Tensioner Pulley, Tension Pulley, Idler Sub-Assembly Timi More. Replaces: 13505-62050, 13505-62060, 13505-20020.
What are the serpentine belts on a Toyota V6?
The serpentine belts are responsible for driving accessories off of the crank of the engine. In the Toyota V6 engines, they drive the alternator and A/C compressor on one belt, and the power steering pump on the secondary belt. Replacing the belts is a good idea if they are worn, cracked or are squealing on cold starts.