What to do if serpentine belt does not adjust?
The tensioner should take the slack out of the belt, but if it does not, the tensioner is faulty and replacement is the only fix. If the adjustment works, reconnect the negative battery terminal to the battery and tighten the retaining bolt with a wrench. If the adjustment does not work, remove the tensioner and replace it.
How to replace the serpentine belt in a Jeep Grand Cherokee?
Rotate the belt tensioner pulley, using the wrench, to and relieve tension on the belt. Slip off the old belt and slowly release the tensioner pulley. Use your belt routing diagram to put the new belt onto all of the pulleys. Pay close attention to the water pump pulley, as incorrect routing can cause the water pump to run backwards and overheat.
Where is the serpentine belt on a Chevy?
Locate the serpentine belt on the front of the engine, place a socket on the center of the tensioner’s idler bolt, then attach a breaker bar to the socket.
How do you remove a belt from an auto tensioner?
Hold the tension from the belt, and slip the belt off the auto tensioner pulley to remove the belt and pulley system. Slowly release the tension to avoid damage or injury, and then remove the tool from the belt auto tensioner.
Where do you put the serpentine belt on a Pontiac Grand Prix?
To release the tension on the serpentine belt, place the 15mm socket on the pulley and push the long handled socket wrench towards the rear of the car. I recommend buying the Bando 6PK2325 serpentine belt since it has excellent reviews on Amazon.
When to replace the serpentine belt on a GTP?
This “how to” automotive repair guide was specifically written to assist owners of the 6th generation (1997,1998, 1999, 2000, 2001, 2002 & 2003) General Motors Pontiac Grand Prix GTP in replacing the serpentine (accessory) belt. Owners of other GM cars with engines similar to the 3800 Series II 3.8 Liter V6 may also find the guide to be useful.
How do you loosen the supercharger belt on a Pontiac Grand Prix?
Pull the wrench towards the front of the car to release the tension on the supercharger belt. While holding the wrench in this position, slip the supercharger belt off the supercharger pulley. If you can’t slip it off, rotate the wrench more towards the front of the car to further loosen the belt.
How do you remove a serpentine belt from a car?
Pull the belt off of the pulleys. With the tension relieved from the belt, pull it off of the pulley that has been placing tension on it, then remove it from the around the rest of the pulleys on the engine. If the belt is severely damaged, be sure to remove any parts that may have come off of it as well.