How do you remove the governor on a scooter?

How do you remove the governor on a scooter?

Take the faceplate off of the front pulley wheel to access the governor washer. Pull the governor washer off of the pulley rod by hand.

How do you remove Governor from Honda variator?

Pull the governing washer off of the front pulley rod. This washer acts as a governor for your scooter, restricting the speed at which your variator’s belt can run. Replace the front pulley wheel and tighten the bolt holding it in place. You will need to secure the wheel with your strap wrench to sufficiently tighten the bolt.

Can a 50cc Scooter be derestricted and still run?

Most 50cc scooters are restricted by the placement of a spacing washer in the drivetrain system, also known as the variator system. Removing this washer allows the scooter’s variator system to operate at its full potential, increasing the scooter’s acceleration and top speed. Step 1

How do you remove the kick stand from a scooter?

Remove the kick stand. Pull the pin attaching the scooter to the variator box up and out and then pull the kick stand off of the box. Set the kick stand aside. Unscrew and remove the two bolts holding the plastic cover of the intake box if your scooter has one.

Take the faceplate off of the front pulley wheel to access the governor washer. Pull the governor washer off of the pulley rod by hand.

Pull the governing washer off of the front pulley rod. This washer acts as a governor for your scooter, restricting the speed at which your variator’s belt can run. Replace the front pulley wheel and tighten the bolt holding it in place. You will need to secure the wheel with your strap wrench to sufficiently tighten the bolt.

How do you get rid of Kickstart on 50cc Scooter?

You will notice it is held by a pin that is connected to a small bolt. Look for the bolt and start to loosen it until you’re able to pull the pin. Once the pin comes loose, you’ll be able to get rid of the kickstart. You can start to look into the variator system at this point.

How do you remove a restriction on a 50cc Scooter?

Simply grind off the small welding spot that hold the restriction in place and it can be easily removed. To avoid that the restriction piece falls into the manifold when grinding you should build a hook out of some wire and secure its position. There are some other exhaust restrictions.

How do you remove the variator from a scooter?

Unscrew and remove the two bolts holding the plastic cover of the intake box if your scooter has one. Some scooters do not have this covering, in which case you can directly access the variator box from the outside of the scooter. Unscrew and remove the bolts of the variator case lid. There are six bolts around the edge of the box.

What happens when you remove the governor from a scooter?

Removing this washer from the variator ostensibly removes the scooter’s governor. Removing your scooter’s governor washer from the variator system removes the operating speed regulations for your scooter’s engine, allowing your scooter to travel faster. Remove the kick stand.

How to remove the governor for a 50cc Honda Metro scooter?

Removing the governor of your 50 cc Honda Metro scooter will certainly increase its speed, and it may even enable it to travel fast enough that you may need to reregister the vehicle as a larger class motorcycle. Pull out the pin attaching the kickstart to the variator case of your Honda Metro.

Unscrew and remove the two bolts holding the plastic cover of the intake box if your scooter has one. Some scooters do not have this covering, in which case you can directly access the variator box from the outside of the scooter. Unscrew and remove the bolts of the variator case lid. There are six bolts around the edge of the box.