How do you reset the pass lock on a 2005 GMC Canyon?
To reset the 2005 GMC Canyon passlock You will start off by turning the ignition key to the “Run” position after two to three seconds. Leave the key in this position for 10 minutes. Start the engine as soon as the security light stops flashing and remains on. The Passlock system resets and the engine starts normally.
How does a PassLock system relearn procedure work?
If the IPC/BCM receives the expected coded signal, the IPC/BCM will send a message over serial data to inform the PCM that the vehicle may be started. To perform a relearn on a Passlock system, make sure there is a fully charged battery in the vehicle.
How long does it take to reset PassLock on Chevy?
Passlock Reset procedure. Reset security system on chevy, buick, oldsmobile, cadillac, pontiac, saturn, hummer. Make sure the battery if fully charged because this procedure may take up to 30 minutes and you cannot start the vehicle during this time.
How to do a security system Relearn on your own?
Preforming a Relearn on your Security System on your own. Attempt to start the truck by turning the key to the Start/Run position. Try to crank the vehicle. Observe that the vehicle fails to start and the security light is illuminated. Allow the vehicle to sit with key in the ON/RUN position for no less than 11 minutes.
What happens when you add a new key to PassLock?
If you’re adding a new key to the system, you MUST have all the older keys with you. All previously learned keys will be erased from the system as soon as you program the first key.
How to do a Relearn on a PassLock system?
To perform a relearn on a Passlock system, make sure there is a fully charged battery in the vehicle. The battery will be used for 30 minutes without the alternator available for charging. Connect a battery charger to the battery to ensure power is available while programming.
How to relearn the passkey II security module?
To perform a relearn on a Passkey II system, make sure there is a fully charged battery in the vehicle. The battery will be used for 30 minutes without the alternator available for charging. Connect a battery charger to the battery to ensure power is available while programming.
How to reset PassLock 3 security system on Chevy?
But here are some more articles to help Passlock III reset procedure, reset security system on chevy, buick, oldsmobile, cadillac, pontiac, saturn, hummer. Passkey III Reset procedure. Make sure the battery if fully charged because this procedure may take up to 30 minutes and you cannot start the vehicle during this time.
How long does it take to reset PassLock 3?
Passlock III reset procedure, reset security system on chevy, buick, oldsmobile, cadillac, pontiac, saturn, hummer. Passkey III Reset procedure. Make sure the battery if fully charged because this procedure may take up to 30 minutes and you cannot start the vehicle during this time.