How do you program a keyless remote for a 2006 Saturn Vue?
Hold down the “Lock” and “Unlock” buttons on the keyless entry remote for at least seven seconds. Release the “Lock” and “Unlock” buttons after you hear the Vue’s power locks perform a locking or unlocking cycle. The keyless entry remote is now synchronized to your Saturn Vue.
How do you program a Saturn key fob?
Repeat the programming sequence–by holding the lock and unlock buttons–on your next remote. Do this within one minute and wait for the locks to cycle again to indicate successful programming. Repeat again with any additional remotes, up to four, and be sure to do it within a minute and wait for the locks after every remote.
How long does it take to program a Saturn Remote?
Release the buttons once the locks cycle and that remote will be successfully programmed. Repeat the programming sequence–by holding the lock and unlock buttons–on your next remote. Do this within one minute and wait for the locks to cycle again to indicate successful programming.
How do you turn off the FOB on a car?
Make sure that the ignition is not in the radio mode, and do not start the engine. With the key in the ‘On’ position, press the fob’s lock button and turn the key back to the ‘Off’ position. Repeat this process at least three times, ending the cycle with the key in the ‘On’ position.
How long does it take to program key fobs?
If there are additional remotes, press the ‘Lock’ button within 10 seconds after you enter the programming mode to program those remotes as well successfully. Once the above steps are performed, turn the ignition back to the ‘Off’ position to terminate the programming procedure. Take your key fobs with you and leave the vehicle and close all doors.
Repeat the programming sequence–by holding the lock and unlock buttons–on your next remote. Do this within one minute and wait for the locks to cycle again to indicate successful programming. Repeat again with any additional remotes, up to four, and be sure to do it within a minute and wait for the locks after every remote.
Release the buttons once the locks cycle and that remote will be successfully programmed. Repeat the programming sequence–by holding the lock and unlock buttons–on your next remote. Do this within one minute and wait for the locks to cycle again to indicate successful programming.
Where is the data port on a Saturn?
Insert your key into the ignition and leave the key in the “Off” position. Locate the car’s data port on beneath the dash board panel on the driver’s side. Notice the eight data terminals on each side of the port and connect the jumper wire to the 8 and 4 terminals, which are eighth and fourth from the left side of the port on the top side.