What does code p0340 mean on a Saab?
With code P0340 your engine controller limits torque and you loose a good third of your available power. When you replaced coil packs did you use aftermarket or genuine Saab and are all 4 coil packs the same manufacturer?
What is the engine code for a 2003 Saab 9-3?
As far as symptoms associated with this code P0340, i am having a loss in power and what seems like a rapid misfire. Currently P0340 is the only engine code I have. Any and all help with this issue would be much appreciated. You do get codes for these, but you don’t have a cam position or separate knock sensor on this engine.
Where is the ion module on a Saab 9-3?
The ION module is on end of engine, upper right rear near brake and coolant reservoir, rectangular plug wire bundle leads to coil packs.
What to do if your camshaft position sensor says p0340?
Visually inspect the camshaft position sensor connector in search of corroded or broken connectors. Make any other repairs (if other codes are present) to make sure that other codes are not sources of the trouble code P0340. Check your camshaft position sensor’s voltage, ground, and signal readings with a multimeter.
What causes the p0340 code on a Saab 9-3?
Saab 9-3 P0340 Causes As stated above, the P0340 code is often caused by a failure in the Camshaft Position Sensor itself. Here are the most common causes: Wiring Issue– The Camshaft Position Sensor wiring is exposed to harsher conditions than a lot of the wiring in your 9-3.
As far as symptoms associated with this code P0340, i am having a loss in power and what seems like a rapid misfire. Currently P0340 is the only engine code I have. Any and all help with this issue would be much appreciated. You do get codes for these, but you don’t have a cam position or separate knock sensor on this engine.
What are the symptoms of a Saab 9-3 CPS malfunction?
P0340 Symptoms: Saab 9-3. The CPS helps an engine determine optimal timing for combustion. When it is not functioning properly, it can cause a lot of drivability problems in your 9-3. They include: Failure to Start. Poor Idle Quality. Decreased Fuel Economy. Drop in Engine Power.
The ION module is on end of engine, upper right rear near brake and coolant reservoir, rectangular plug wire bundle leads to coil packs.