How to diagnose a p0705 Saab transmission malfunction?
Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost to diagnose the P0705 SAAB code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
What is the PNP switch on a Saab?
The park/neutral position (PNP) switch includes a transmission range switch. The transmission range switch detects the selector lever position when the shift lever is in the N or P shift position and sends a signal to the Transmission Control Module (TCM). Need more information on how to fix the P0705 SAAB code?
What does fault diagnosis on Saab Turbo mean?
Fault diagnosis concerns a leak in the hose to the sensor or between the compressor and the throttle body. • Diagnostic status for the diagnosis. • Pressure sensor value, unit kPa. During acceleration, the value should exceed the value for the two other pressure sensors.
What’s the p / n code for a Saab Turbo?
I’m ready to try replacement of this next to eliminate the 1105 and 1106 fault code. According to the EPC is the original P/N 55 560 162 “No Longer Serviced” – obsolescent – , replaced by 91 97 948, then 30 584 326 and finally by 55 563 262.
Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost to diagnose the P0705 SAAB code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type.
The park/neutral position (PNP) switch includes a transmission range switch. The transmission range switch detects the selector lever position when the shift lever is in the N or P shift position and sends a signal to the Transmission Control Module (TCM). Need more information on how to fix the P0705 SAAB code?
What causes a trouble code on a Saab?
Even trouble codes indicating misfiring or an adaptation fault may occur in case of a major air leak. • Catalytic converter or exhaust system blockage. If the flow of exhaust from the turbocharger is obstructed too much, the turbine speed will not be high enough to provide sufficient boost pressure.
Why is my p1105 code and Turbo not working?
This DTC is generated if the turbocharger is not able to build up pressure when the enable criteria for the diagnosis have been fulfilled. This can be due to any of the following causes: • Defective turbo unit, e.g. open wastegate valve or sticking turbine shaft. • Major air leak between turbocharger and throttle body.
How does speed sensor work on Saab p0502?
The vehicle speed sensor outputs a 4 pulse signal for every revolution of the rotor shaft, which is rotated by the transmission output shaft via the driven gear. After this signal is converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter, it is then transmitted to the ECM.
What to do if your transmission code is p0705?
What repairs can fix the P0705 code? 1 Repairing an open or short in the TRS circuit 2 Replacing a faulty TCM 3 Replacing a faulty ECM 4 Changing the transmission fluid and filter 5 Adjusting the linkage connecting the shift lever on the transmission to the gear shifter inside the car
https://www.youtube.com/watch?v=SNGT3g1tgAY