Where is the drain bolt on a Saab 9-5?
The drain bolt is located to the right of the exhaust when looking from the front of the car. It’s the only 24mm bolt in that area so you can’t mistake it for anything else. There is not enough room for a socket so an open-ended or ring wrench/spanner is needed.
How often should I change the fluid in my Saab 9-5 Aero?
But 89% of new ATF seems good enough for most. You can change the fluid an infinite number of times and you’ll never get all the old fluid out. This the old and new fluid on a 5-year old 2005 9-5 Aero with 75K miles. The drain bolt and the washer.
What is the P number on a Saab 9-3 alarm?
Original P/number is 12783781.Saab 9-3 Alarm Remote Fob/Transmitter. 433.92mhz. NEW REMOTE FOB/TRANSMITTER!! Saab Griffin logo for the hood. This is an Original Equipmet Part. Utilizing a plastic wedge or flat tip screw driver you need to pry off the existing silver disc.
What happens when you change the ATF in a Saab?
The ATF will start draining out slowly when the bolt is almost at its end. Removing the bolt will make the fluid gush out because it’s a pretty large opening. Because the engine is warm/hot, this fluid can be very hot so be very careful not to get it all over your hands or arms. It really can cause severe burns.
What kind of engine does Saab 9 5 2.3T have?
The Saab 9 5 2.3t has a Inline 4, Petrol engine with 2290 cm3 / 139.7 cu-in capacity. How many horsepower (hp) does a 2001 Saab 9 5 2.3t have? The 2001 Saab 9 5 2.3t has 185 PS / 182 bhp / 136 kW.
How do you change ATF in a Saab 9-5?
About 4 quarts/liters is drained every time so fill up the transmission with 4 quarts/liters of new ATF. The fluid is added through the dipstick tube. Warm up the engine. Shift through Drive and Neutral so the fluid can get distributed through the transmission. Check the fluid level and add if necessary.
What’s the fluid level in a Saab 9-5?
See Automatic transmission fluid level, Automatic transmission, transmission fluid level without dipstick or Fluid level check, 4-cyl diesel. The difference in volume between the max and min marks is as follows: B205, B235: 0.5 l Diesel: 0.3 l. Fit the lower engine cover.
The drain bolt is located to the right of the exhaust when looking from the front of the car. It’s the only 24mm bolt in that area so you can’t mistake it for anything else. There is not enough room for a socket so an open-ended or ring wrench/spanner is needed.