Where is the heater bypass valve on a Saab 9-5?
This is also known as the heater/coolant bypass valve. These instructions are for the 2005 Saab 9-5 but should be the same for all model years. The solenoid valve is located in front of the bulkhead above the water shut-off valve. 1. Open the expansion tank cap and release any overpressure. Refit the cap.
Where is the check valve on a Saab 9-5?
2002 Saab 9-5 with 114,000 miles. Here some more pictures from when I changed my valve last year. Hose clamp pliers make it a lot easier to get the hoses off. The vacuum line with the red/white check valve plugs into the end of the solenoid.
Can a mechanic replace a coolant valve switch?
Ideally, the job of replacing a coolant vacuum valve switch is one that should be completed by a certified mechanic when possible. Anytime you work with an engine’s vacuum system, it is vital to replace vacuum lines precisely where they were originally attached.
Is there a crack in the coolant valve?
Check the coolant vacuum valve switch and any vacuum line connections before replacing the unit. Coolant leaking under the vehicle or in the cab: This symptom is extremely rare, however it can occur, especially if the crack in the coolant vacuum valve switch is significant enough.
How do you change the thermostat on a Saab 9-5?
Open the cap on the expansion tank and release the pressure. 2. Raise the car. 3. Remove the lower front cover. 4. Drain off the coolant. 5. Lower the car to the floor. 6. Loosen the hose clamp on the upper radiator hose mounting at the thermostat housing. 7. Move the hose to one side. 8.
What should I use to replace the coolant sensor on a Saab 9-5?
Basic pliers should work as well. 19mm wrench shown is only needed to replace the coolant temperature sensor (not part of this tutorial). Thermostat with rubber gasket. Saab part no 30577561
How does the brake light work on a Saab?
When a Saab dies, the world becomes a little less quirky. The ! light in triangle, Central Warning Lamp (not the gearbox one) and brake (fluid) light will be turned on when the ABS lamp is lit. The ABS – and TC/ABS modules are powered by the #2 Maxi Fuse, 50 A, in the engine bay main fuse board, to be checked.
What happens when a coolant bypass valve fails?
When you turn of the ignition, the vaccuum tube is no longer active and the valve is turned on by default. If you open the top of a faulty Bypass Valve (which is easy to do) you will see that there is a rubber diaphragm with a pin in centre that is activated (lifted) by the vacuum. This opens up passage of hot coolant to the heater.
What kind of Turbo bypass valve does a Saab have?
Saab: Turbo bypass valve (hooter valve) for any 16v 900 85-98, 9000 86-88, 91-98 all, 9-3 all, 9-5 all. Volvo: Turbo by-pass valve for any S80 turbo 99-06. 1 per car. Vehicle Fitment: SAAB: 9-3 1999-03 | 9-5 1999-09 | 900 1985-98 | 9000 1986-88 | 9000 1990-98 – Volkswagen: Beetle 1999-00 | Golf 2000-01 | Jetta 1999-01 – Volvo: S80 1999-05
This is also known as the heater/coolant bypass valve. These instructions are for the 2005 Saab 9-5 but should be the same for all model years. The solenoid valve is located in front of the bulkhead above the water shut-off valve. 1. Open the expansion tank cap and release any overpressure. Refit the cap.
2002 Saab 9-5 with 114,000 miles. Here some more pictures from when I changed my valve last year. Hose clamp pliers make it a lot easier to get the hoses off. The vacuum line with the red/white check valve plugs into the end of the solenoid.
What kind of car is a Saab 9-3?
Vehicle Fitment: SAAB: 9-3 1999-03 | 9-5 1999-09 | 900 1985-98 | 9000 1986-88 | 9000 1990-98 – Volkswagen: Beetle 1999-00 | Golf 2000-01 | Jetta 1999-01 – Volvo: S80 1999-05 WARNING: This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
When did the first Saab 9-5 come out?
In this article, we consider the first-generation Saab 9-5 (YS3E), produced from 1997 to 2009.
Where are the fuse panels on a Saab 9-5?
Here you will find fuse box diagrams of Saab 9-5 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008 and 2009, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout) and relay.
What is the P number on a Saab 9-3 alarm?
Original P/number is 12783781.Saab 9-3 Alarm Remote Fob/Transmitter. 433.92mhz. NEW REMOTE FOB/TRANSMITTER!! Saab Griffin logo for the hood. This is an Original Equipmet Part. Utilizing a plastic wedge or flat tip screw driver you need to pry off the existing silver disc.
What kind of spark unit does a Saab use?
Saab Genuine Direct Ignition Module (55559955) – 9-5 and 9-3 OEM. 1 YEAR PART WARRANTY! Genuine Saab Direct Ignition Cassette. Distributes spark. Note: This unit is Black, and is not interchangeable with the Red unit.
Why is YouTube not working on my Saab 9-5?
If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. I Bought the Cheapest Saab 9-5 in the US!
What kind of car is a Saab 9-5?
To avoid this, cancel and sign in to YouTube on your computer. I Bought the Cheapest Saab 9-5 in the US! (Non-Running) A car channel created by car guys for car guys! My current cars include a 2008 Saab 9-3 Turbo X (Maptun Stage 2), 2003 Saab 9-3 (Stage 3) and 1995 Mazda Miata.
What kind of engine does a Saab 9-3 have?
Affected models include the 2000-03 Saab 9-3 and 1999-2003 Saab 9-5. This video is put up specifically for the SAAB Central Forum. It’s a head gasket replacement and sludge cleaning process for 2002 9-3 Viggen.
How long has the Saab 9-5 been in production?
We have now owned and sold many 9-5 models, both petrol and diesel, so believe our own experiences of what to buy will be of great interest to you. The ‘Old 9-5’ was in production for 12 years and by all standards became an outstanding car, especially the Aero models from 2002 onwards.