Why are my wipers not working on my Megane 2?
Renault Megane II wipers not working. UPC blocking the wipers. Fault finding and repair. – YouTube
What’s the problem with my 2 speed wipers?
Yep, can see the problem with the switch in that link; in park it’s shorting 12 Volt out to the 12 Volt out park contact at the motor, while there is no Voltage at all on speed 1 to move the wipers round to the park position.
Why are my wipers not working on my car?
If a contact is loose or corroded, this may cause the wipers to work momentarily. If so, clean and tighten the connectors. If this does not work, examine all the visible wiring to the motor for breaks or damage and repair as required. If this too is not the cause, test the circuits with a multi meter.
How to troubleshoot a Renault wiper with a multi meter?
1 Turn the ignition key to the ON position. 2 Turn on the wiper switch. 3 Wiggle the connectors at the wiper motor. 4 If this does not work, examine all the visible wiring to the motor for breaks or damage and repair as required. 5 If this too is not the cause, test the circuits with a multi meter.
Why are my wipers not working on my Renault Megane?
What could cause the wipers on a 2003 Renault Megane to start on their own or come on when the turn signal is activated? Case Details: The problem occurs when the engine is hot. The problem is likely to be with UPC which is the fuse box/computer located beside the battery. This is the common controller for both the wipers and turn signals.
Why are the wipers on my Renault Modus expression not working?
When the switch fails, the position of the wipers is not sensed and the motor will work only at high speed. The motor will have to be replaced. What could cause the wipers on a Renault Modus Expression to remain on, even with the switch turned to OFF?
What should I do if my wiper is not working?
Open the lid and check for corrosion and damaged connections. Repair as required. If nothing is found, disconnect both the battery cables and leave them off for fifteen minutes. This may reset the system and fix the problem. If after reconnecting the cables the same issue remains, the UPC may have to be replaced.
How to reset the BCM on a Renault wiper?
Resetting the BCM may resolve the problem. To do a reset remove the key from the ignition and disconnect both the battery cables and use a wire to connect them together. Leave the cables like this for thirty minutes and then disconnect them. Reconnect the cables to the battery.