Is the return line on a Porsche 944 swaged?
In this case they do have a collar but it is not swaged at all, really its just a finish ring. One other small point, of the two fuel lines in the original Porsche 944 setup – the return line is a low pressure line and uses a push-on fitting. That line dumps into the fuel tank and only serves to return un-needed fuel.
What kind of fitting does a Porsche 944 use?
Above are another example of push-Lok fitting on a Porsche (928). In this case they do have a collar but it is not swaged at all, really its just a finish ring. One other small point, of the two fuel lines in the original Porsche 944 setup – the return line is a low pressure line and uses a push-on fitting.
What’s the maximum psi of a 944 fuel line?
The 944 fuel system reaches a maximum of about 55 psi, so Push-Lok is a candidate. If you’ve never looked at this kind of fitting, you might think it “needs something” to secure the rubber hose to the fitting.
How much does it cost to replace a 944 fuel line?
These are most commonly used to join the 944 hard lines to the rubber hoses. Yes, Porsche does make replacement fuel lines. I believe these cost about $300 and use a bite-ring union connector to “join-up” with the original fuel lines. This has a bearing on your planning too.
In this case they do have a collar but it is not swaged at all, really its just a finish ring. One other small point, of the two fuel lines in the original Porsche 944 setup – the return line is a low pressure line and uses a push-on fitting. That line dumps into the fuel tank and only serves to return un-needed fuel.
What kind of car is the Porsche 944?
A front-engine, rear-wheel drivemid-level model based on the 924platform, the 944 was available in coupéor cabrioletbody styles, with either naturally aspirated or turbochargedengines. With over 163,000 cars produced, the 944 was the most successful sports car in Porsche’s history until the introductions of the Boxsterand 997 Carrera.
Where can I get a Porsche 944 cylinder replaced?
Clutch master and slave cylinder replacement (version 2) (pelicanparts.com) 944 Paint codes (clarks-garage.com) Control arms general information, rebuild, and aftermarket replacements (clarks-garage.com)
Where can I find a Porsche 944 flow diagram?
Flow diagram and description – Turbocharged 944 (clarks-garage.com) Cooling system draining, filling, and venting (clarks-garage.com) Fan operation and troubleshooting (clarks-garage.com) Troubleshooting cooling system problems (clarks-garage.com) Front oil seal replacement (clarks-garage.com)