Can You short circuit a Porsche Boxster starter?
The starter has a direct connection to the positive terminal of the battery, and you can cause a lot of harm to yourself and the car if you short circuit the terminals (see Pelican Technical Article: Battery Disconnect Switch / Battery Buddy Installation ).
What should I replace on my Porsche Boxster?
With your intake manifold partially disassembled, you can reach many components on the top of the engine. It may be a good time to replace your knock sensors, replace your throttle body, reseal or replace your oil cooler, or replace your air-oil separator.
Do you need to replace Your starter motor?
This is a possible sign that you should replace your starter motor. However, before replacing your starter, check the condition of your battery and make sure you’re your ground strap is properly installed. (see Pelican Technical Article: Battery Disconnect Switch / Battery Buddy Installation ).
Where is the starter located on a pelican?
The starter is located in the engine compartment under the convertible top. The first step in the removal process is to raise the top and gain access to the engine (see Pelican Technical Article: Air Filter / Pollen Filter Replacement).
The starter has a direct connection to the positive terminal of the battery, and you can cause a lot of harm to yourself and the car if you short circuit the terminals (see Pelican Technical Article: Battery Disconnect Switch / Battery Buddy Installation ).
What to do if your Porsche Boxster Fuse has blown?
Switch off the load with the defective fuse. Pull off plastic cover at the finger hole (arrow). Remove the corresponding fuse from its slot using the plastic gripper in order to check it. A blown fuse can be identified by the melted metal strip inside it. Replace only with fuses of the same rating.
With your intake manifold partially disassembled, you can reach many components on the top of the engine. It may be a good time to replace your knock sensors, replace your throttle body, reseal or replace your oil cooler, or replace your air-oil separator.
The starter is located in the engine compartment under the convertible top. The first step in the removal process is to raise the top and gain access to the engine (see Pelican Technical Article: Air Filter / Pollen Filter Replacement).
How to replace a Porsche Boxster starter in 1997?
For 1997-99 cars, you may have to loosen the clamp that holds the accelerator cable in place. With everything disconnected on the throttle body, simply rotate it up and out of the way. You should now have access to the starter, the two bolts attaching it to the engine, and the three electrical connections located on the rear.
Where are the electrical connections on a Boxster starter?
The red arrow points to the two electrical connections (terminal 30 and 50) that are attached to the starter. The green arrow points to the bolt that is generally easiest to remove. The inset photo shows how the three electrical connections are attached to the starter.
What makes a starter motor fail over time?
Starter motors fail over time: it’s just a fact of life. It may be that a starter motor is working fine one day and then all of a sudden dies the next day. Or, sometimes the motor gets weaker and weaker and turns the car over slower and slower.
This is a possible sign that you should replace your starter motor. However, before replacing your starter, check the condition of your battery and make sure you’re your ground strap is properly installed. (see Pelican Technical Article: Battery Disconnect Switch / Battery Buddy Installation ).
Starter motors fail over time: it’s just a fact of life. It may be that a starter motor is working fine one day and then all of a sudden dies the next day. Or, sometimes the motor gets weaker and weaker and turns the car over slower and slower.