What should I do about my Boxster 986 over heating?
Filled the coolant/antifreeze tank twice and drove a short distance about 1/2 mile before it over heated again. Towed it to a mechanic. He could not find any problems with the newly replaced water pump.
Where is the heater located in a Boxster?
The fan (“blower motor”) that blows either hot or cold air into the cabin is located under the dashboard, at the passenger’s (right) side. Here is a diagram of the blower motor (part #8) and its housing, along with the heater core (part #2), through which hot coolant must flow, to produce hot air into the cabin:
What are the common problems with water heaters?
13 Common Water Heater Problems (Tricks to Fix) 1 1. No hot water. If you have no hot water, there are several possible reasons, and you need to work through each of them methodically to eliminate 2 2. Not enough hot water or water not hot enough. 3 3. Water too hot. 4 4. Water takes too long to heat. 5 5. Low water pressure.
The fan (“blower motor”) that blows either hot or cold air into the cabin is located under the dashboard, at the passenger’s (right) side. Here is a diagram of the blower motor (part #8) and its housing, along with the heater core (part #2), through which hot coolant must flow, to produce hot air into the cabin:
What to do if your Boxster engine has no heat?
If you find that the level dropped, you have most likely hit on the solution to your lack of heat problem. Do not open the coolant fill cap while the engine is hot, you could get scalded. Put a rag over the cap as you are unscrewing it for extra safety.
Why is the interior heater in my car not working?
Yesterday my interior heater was working, this morning when I went driving there is no heat or hot air blowing from the vents. Air is blowing from vents but not hot/warm. Can anyone tell me what I need to check for or do? is it a simple fix like a fuse? You can remove these ads by becoming a Contributing Member. fan isn’t working ,or ?
Where is the bleeder valve on a Boxster?
A good (and easy) way to start is to simply lift the bleeder valve lever, which is located under the thin black plastic cover on top of the reservoir tank. Here is a photo of the bleed valve and lever: