When to replace ABS sensor in Porsche Cayenne?
Sometimes, you get lucky and the sensor only needs to be cleaned as brake dust and dirt can sometimes affect the operation of the sensor. If you get a fault code and it points out a failure with a sensor, you may want to remove and clean it before buying a new one. If the fault code re-appears, you may have to replace it.
How to troubleshoot Porsche ABS and PSM problems?
In this guide, we will go over problems that trigger Porsche Anti-lock Brake System (ABS) and Porsche Stability Management (PSM) to malfunction and how to diagnose it yourself using an OBD-II scanner. What does Porsche ABS/PSM light mean?
Where do I find the ABS code on a Porsche?
From the main menu, select Porsche and then the model. Next, you should see all the modules listed. Select either ABS or PSM. Scroll down to Read Faults. Write down all the fault codes. If the codes are STORED status, go back to the main menu, and select Clear fault codes.
What is the Porsche DME fault code 364?
Related fault codes: P0571, P1574 – Brake switch signal implausible. 4340 stop light switch defective, Porsche DME fault code 364. Wire Harness If your Porsche ABS light is caused by no signal coming from the wheel speed sensor, inspect, clean, and, if needed, replace the faulty wheel speed sensor.
What was the PSM failure on my 2004 Cayenne Turbo?
2004 Porsche Cayenne Turbo; was traveling on vacation, PSM failure workshop light and ABS failure workshop lights came on. Stopped at Porsche dealer in NC and code said new wheel sensor was needed. Replace sensor with Porsche parts and again when traveling both lights again came on and continue to come on after new part was installed.Please advise.
What kind of car is 2004 Porsche Cayenne?
Consumer Ratings Rank Vehicles HP #2 2006 Jeep Grand Cherokee 330 #3 2006 Volvo XC90 311 #4 2005 Lincoln Aviator 302 #22 2004 Porsche Cayenne 247
What happens when PSM fails on Porsche Panamera?
PSM failure may come on in a Porsche Cayenne and Panamera. If the PSM light came on after replacing the battery, drive your Porsche for ten minutes, and the PSM light should reset. What you may notice when Porsche PSM fails: Auto-stop/start mode deactivated, flashes.
How do you check the ABS on a Porsche?
Locate the diagnostic port under the dashboard on the driver’s side and plug in your scanner. Turn on the ignition but do not start the engine. If your Porsche has a start/stop button, press it without pressing the brake pedal. Turn on the scanner ” select Porsche and then your specific model. Scroll to the ABS / PSM module.