Do you have to re program the ignition lock cylinder?
Ignition Lock Cylinder: Do I Have to Re Program It After I Replace… Do I have to re program it after I replace the key lock cylinder? have the same problem?
When do you need to relearn the ignition switch?
The Hall effect or Passlock sensor inside the lock cylinder housing goes bad intermittently and the Body Control module forgets the code or signal from the sensor and the 10 minute relearn procedure needs to be done in order to get the vehicle started. We do it all of the time at the shop for our customers.
How to relearn Ford Passive Anti-Theft System ( PATS )?
Replacing PCM only — A or D type PATS If only the PCM is being replaced on a PATS control function type A or D vehicle, no relearn is required (please refer to the Ford PATS chart to determine PATS type). Simply put the original key in the ignition, turn to ON or RUN and wait for 20 seconds. Then turn the key off and start vehicle.
Is there a relearn procedure for Ford SecuriLock?
JDB2080 PT 78-0004. Passive Anti-Theft Systems (PATS), also called Ford Securilock, is a vehicle security feature introduced on 1996 and later Ford vehicles. When replacing the Powertrain Control Module (PCM) on a PATS-equipped vehicle, a parameter reset or relearn procedure must be performed after the PCM is installed.
How do you change the ignition lock cylinder?
Turn the ignition key to the ACC, START, or RUN position as specified in the repair information. Align the lock cylinder with the keyway in the housing and the slot for the retaining tab. Push the lock cylinder in so that the locking tab locks against the housing. Reinstall the trim panels you removed to access the lock cylinder.
How does Ford passive anti-theft system relearn procedures?
Enter Security Access on the PATS control function module. For type B, it will be the PATS module, for type C, the Instrument Cluster, for type F, the PCM, for type G, the Instrument Cluster Module. (This takes 10 minutes). 3. Select “Parameter Reset” and exit Security Access. 4. Select a PCM Keep Alive Memory (KAM) reset. 5. Start vehicle.
Do you need a chipped key to replace an ignition cylinder?
Note: On vehicles equipped with an immobilizer system and a transponder “chipped” key, for the vehicle to run, you will need to perform an anti-theft relearn procedure after installing the new lock cylinder and key. This often requires the use of an OEM-level scan tool or a dedicated key programming tool.
JDB2080 PT 78-0004. Passive Anti-Theft Systems (PATS), also called Ford Securilock, is a vehicle security feature introduced on 1996 and later Ford vehicles. When replacing the Powertrain Control Module (PCM) on a PATS-equipped vehicle, a parameter reset or relearn procedure must be performed after the PCM is installed.