How do you change a lock cylinder key?
Cut a blank key to the proper level (1) of each of the tumbler positions (2). 2. Remove any rough edges from the key using a wire brush or wire wheel. 3. Inspect the key operation in the lock cylinder. Replacement Lock Cylinders The lock cylinder keyway is designed so that other model keys will not enter a current model lock cylinder.
How to determine mechanical code for lock cylinder?
After the mechanical key code has been determined from the code list , perform the following steps: 1. Cut a blank key to the proper level (1) of each of the tumbler positions (2). 2. Remove any rough edges from the key using a wire brush or wire wheel. 3. Inspect the key operation in the lock cylinder. Replacement Lock Cylinders
Where is the ignition lock cylinder core located?
Remove the ignition lock cylinder core from the ignition lock cylinder housing. 1.1. Insert the key into the ignition lock cylinder. 1.2. Rotate the lock cylinder core to START. 1.3. Press the lock cylinder core retainer located in the end of the ignition lock cylinder. 1.4.
How do you break ignition button lock cylinder?
Carefully drill a larger hole at the pilot location, and slightly into the ignition switch lock cylinder surface to break the release button retaining spring using a 9/32 inch drill bit. 2.5. Remove portions of the broken spring from the hole using a small suitable tool. 2.6.
How do you lock a cylinder in a Ford?
Lock the cylinder- insert a paperclip into the slot and turn to the left to lock the cylinder and avert the ignition from starting. Insert the screwdriver into the cylinder and break the ignition lock with a screwdriver. Turn the cylinder to the right as far you can, pull the paperclip on the far right, then slide the switch out of its place.
How do you remove steering shaft lock cylinder?
If you wish to eliminate the Steering Shaft Lock feature, remove the swaged in cover piece on the side of the Steering Lock Housing and drive the the lock shaft out of the housing thru this opening. If you use the new lock cylinder you will also have to use the new ignition keys that come with it, thus having two different keys for the car.
How do you remove the ignition lock cylinder?
To remove the ignition lock cylinder core from the ignition lock cylinder housing, do the following; Slide the key into the ignition lock cylinder. Rotate the lock cylinder core to START, ACC, or RUN position as per the repair information.
How do you get the lock out of a BMW pannier?
Once out, I realized with careful use of a paper clip you can get the lock cylinder out without any disassembly. This is how I removed the lock cylinder in the second pannier. You have to be able to slide a locking tab at the bottom of the lock cylinder towards center while also pulling up so the lock cylinder can slide out.