Can you run a car up to 6, 000 rpm?
If the engine were operating properly and properly maintained, running it up between 5,000 and 6,000 during acceleration would be no problem whatsoever. But you do not have an engine operating properly. You have an engine with unknown problems.
When do I put my truck in drive, the RPMs go up?
When I put my truck in drive and step on the gas the RPM’s go up to 3,000 but my MPH will stay at 10-15 When I let go of the gas a little bit I can feel the truck kind of pull and the RPM’s will g… Stack Exchange Network
What to do if your car RPMs are too high?
Try filling it, running it and putting it in various gears to drive air out, then filling it again. Wash rinse repeat that until the level is correct and see if you still have the issue. Hope this helpful and good luck.
Can you drive a Subaru at 3500 rpm?
If I owned a Subaru with 170K miles on it I would be afraid to take it much over 3500 RPM. Flogging tired, old, engines might be “fun” but I’m afraid the fun won’t last very long…When a rubber timing belt snaps at 6000 RPM, Ka-Ching!! That will be Four Grand Please… the_same_mountainbike July 5, 2016, 11:29pm #4
What happens when you go over 4000 rpm?
The engine computer has a built in rev limiter built in to the programming that will not let the engine go above 3800 to 4000 rpms when the transmission is not in gear and driving down the street. This is a normal protection so you do not over rev the engine and damage it. Was this answer helpful? Thank you for your feedback! Sorry about that.
If the engine were operating properly and properly maintained, running it up between 5,000 and 6,000 during acceleration would be no problem whatsoever. But you do not have an engine operating properly. You have an engine with unknown problems.
When I put my truck in drive and step on the gas the RPM’s go up to 3,000 but my MPH will stay at 10-15 When I let go of the gas a little bit I can feel the truck kind of pull and the RPM’s will g… Stack Exchange Network
Try filling it, running it and putting it in various gears to drive air out, then filling it again. Wash rinse repeat that until the level is correct and see if you still have the issue. Hope this helpful and good luck.