When to use diagnostic trouble code p1650 and p1651?
The Diagnostic Trouble Code (DTC) P1650 and P1651 will set if there is an open, short to ground or short to voltage on any of the QDM output circuits, faulty MIL circuit, faulty upshift light circuit, faulty cooling fan relay circuit or A/C relay circuit. Fault detected for 5 seconds will set P1651. Fault detected for 20 seconds will set P1650.
What is the p1651 fan 1 relay control circuit?
I have the same code. 2002 Grand Prix GTP 3.8L Supercharged. For your Pontiac, the P1651 code is for the Fan 1 Relay Control Circuit. Read more: http://engine-codes.com/p16… I found the fuse which is one of those big 30A fuses. It was blown hopefully once that’s replaced it’ll fix that error code and then I can figure out the P0140 code I get.
How much does it cost to repair a p1651 code?
Check for damaged components and look for broken, bent, pushed out, or corroded connector’s pins. The cost of diagnosing the P1651 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
What does the OBD II fault code p1351 mean?
OBD II fault code P1351 is a manufacturer specific code that most carmakers define as “Ignition Control Module Circuit Voltage”, or sometimes as “Ignition Control Module Circuit High Voltage”. This code is set when the PCM (Powertrain Control Module) detects an abnormal voltage in the control circuit of the ICM…
The Diagnostic Trouble Code (DTC) P1650 and P1651 will set if there is an open, short to ground or short to voltage on any of the QDM output circuits, faulty MIL circuit, faulty upshift light circuit, faulty cooling fan relay circuit or A/C relay circuit. Fault detected for 5 seconds will set P1651. Fault detected for 20 seconds will set P1650.
I have the same code. 2002 Grand Prix GTP 3.8L Supercharged. For your Pontiac, the P1651 code is for the Fan 1 Relay Control Circuit. Read more: http://engine-codes.com/p16… I found the fuse which is one of those big 30A fuses. It was blown hopefully once that’s replaced it’ll fix that error code and then I can figure out the P0140 code I get.
Why does my car have an error code of p1151?
An air leak after your mass air flow sensor or a leaking gasket in your EGR system could be the cause. Improperly seating your engine oil dipstick could also result in this error code. Your base engine could be experiencing cylinder compression, issues with cam timing or have an oil overfill.
When does a QDM fault set p1651?
Fault detected for 5 seconds will set P1651. Fault detected for 20 seconds will set P1650. The QDM circuit is continuously checked when the engine is running.