What to do if your Pontiac G6 wont restart?
Open the G6 door and insert your key into the ignition. Turn the ignition key to crank the engine. If the car will not restart, use a secondary car key to crank the engine. If neither work, then continue to step 3. Listen to the engine as you try to crank it.
How does the pass key work on a Pontiac G6?
Newer versions of the Pontiac G6 use a passive ignition immobilizer system called PASS-Key III. The system uses radio frequencies to communicate with the key fob you use to start the G6. When you place the key into the ignition, the key and car communicate to ensure the key is legit.
What to do if your G6 key is stolen?
When you place the key into the ignition, the key and car communicate to ensure the key is legit. If the theft system does not get the correct frequency back from the key, it will not allow you to start the car. Use the correct G6 key to restart your vehicle. Open the G6 door and insert your key into the ignition.
Where are the fuses on a Pontiac G6?
Locate the engine compartment fuse box under the front hood near the engine block on the driver’s side. The box has an electricity symbol on the front. Pull off the cover and then remove the fuse box to take a look at the fuses. Check fuse number 32. This is the Run/Crank relay.
Open the G6 door and insert your key into the ignition. Turn the ignition key to crank the engine. If the car will not restart, use a secondary car key to crank the engine. If neither work, then continue to step 3. Listen to the engine as you try to crank it.
When you place the key into the ignition, the key and car communicate to ensure the key is legit. If the theft system does not get the correct frequency back from the key, it will not allow you to start the car. Use the correct G6 key to restart your vehicle. Open the G6 door and insert your key into the ignition.
Newer versions of the Pontiac G6 use a passive ignition immobilizer system called PASS-Key III. The system uses radio frequencies to communicate with the key fob you use to start the G6. When you place the key into the ignition, the key and car communicate to ensure the key is legit.
Locate the engine compartment fuse box under the front hood near the engine block on the driver’s side. The box has an electricity symbol on the front. Pull off the cover and then remove the fuse box to take a look at the fuses. Check fuse number 32. This is the Run/Crank relay.
Why does my G6 not start when I turn the key?
This just means that the engine doesn’t move when you turn the key. The second way that your G6 won’t start is when the engine turns when you engage the starter, but it won’t fire and run on its own. When the engine isn’t turning over at all, that’s a bit easier to diagnose than when it is cranking but not firing.
How long does it take to turn off a GM security light?
Leave the key in the “ON” position for approximately 11 minutes. The security light will be steady on or flashing for the 11-minute period. Do not proceed to Step 2 until the security light turns off or stops flashing. 2. Turn the ignition switch to the “OFF” position for 30 seconds. 3.
Where is the run / crank relay on a Pontiac G6?
This is the Run/Crank relay. It is the large fuse located in the center towards the bottom of the console. If the silver color band in the fuse is burnt or broken, you have a blown fuse that needs to be replaced before the car will restart.