Do you need to replace the airbag control module?
Additionally, you might be able to replace the airbag control module with some basic tools and know-how, thereby saving you more money on the labor costs. Once the replacement of the airbag control module is complete, you may also need your diagnostic tool to reset the codes and turn the SRS warning light off.
How does my airbag module reset and return work?
MyAirbags is committed to helping you reset your airbag module and seat belts. We provide a reset and return service to reset airbag control modules. This service requires you to remove and send your module to us for reset. When we receive your airbag module, we reset ALL fault codes.
What happens when an airbag module is unmatched?
The repaired module MUST GO BACK INTO THE SAME VEHICLE FROM WHICH IT WAS TAKEN. Airbag modules are matched to a specific car, like an address. Each airbag module is matched with all or part of the vehicle’s VIN. Unmatched modules will usually cause the airbag light to illuminate.
Where are hard codes stored in an airbag control module?
Airbag control modules store hard and soft codes caused by accidents. Even after small accidents, fault codes will be stored in the module which will turn on the airbag light. We reset and clear all of these crash codes inside the computer module in order to turn off the airbag light.
What happens if there is no airbag control module?
As a result, driving without a properly operating airbag control module can serve as a giant safety hazard. During a collision, airbags are what prevent occupants of a vehicle from colliding into other objects or people inside the vehicle or from completely projecting through the windshield.
MyAirbags is committed to helping you reset your airbag module and seat belts. We provide a reset and return service to reset airbag control modules. This service requires you to remove and send your module to us for reset. When we receive your airbag module, we reset ALL fault codes.
Where is the SRS airbag control module located?
In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.
Do you need to have your airbag module coded to your Vin?
One of the biggest benefits of letting MyAirbags repair your airbag module is that you will not need to have the module coded to your vehicle VIN since it is original and came out of your vehicle. This will save you time and money! SRS Airbag Reset: SRS Airbag Light On?