How do you remove the ignition switch from a Pontiac?
Unplug the yellow wiring harness on the steering column with your hands, then unplug the remaining wiring on the column. Remove the ignition switch actuator rod from the ignition switch using the Phillips-head screwdriver. Remove the ignition switch from the car.
What to do if your ignition switch is not working?
If the switch is not working, you will likely have to remove and replace it. You can do this with a set of simple tools like a screwdriver. Turn on your power drill and use your drill bit to make a hold in the key slot of the ignition cylinder.
How to remove the ignition switch in a 1999 Pontiac Sunfire?
Turn it to the “Run” position, but do not start the Sunfire. Locate the locking button located on the backside of the ignition cylinder housing. Push the button and then pull the lock cylinder away from the column. Unscrew the ignition switch from the steering column using the Phillips head screwdriver.
Where is the ignition switch on a car?
These switches are located just to the side of the steering wheel and column on your dashboard, and are one of the main components in your car’s starter system. If the switch is not working, you will likely have to remove and replace it.
Where is the electronic ignition switch located on a GM car?
A typical symptom of failure is the security light illuminating on the dash. Also, keep in mind the electronic ignition switch is located just behind the lock cylinder. It is the plastic part that the ignition lock cylinder fits into. It contains the actual electrical connections and wiring and it sends current to numerous different components.
How to replace a no start ignition switch?
GM Ignition switch replacement to fix a no start or intermittent start. Faulty ignition switch contacts can also cause the PassLock system to enable Click here to see step by step proceedures. http://www.thejunkmanadv.com/the-junk… Support the site, buy service manuals here : http://www.tkqlhce.com/click-7357719-… Loading…
How to replace GM PassLock ignition key lock cylinder?
Press the small release tab (see pictures) While turning key to the ON Position Installation is the reverse of the above procedures, see below for the relearn procedure Clear all Diagnostic Trouble Codes (DTC). Record and/or repair your DTCs before clearing. You can clear the codes by disconnecting the battery for 10 minutes.
Where is the headlight switch on a car?
Headlight Switch. What is a headlight switch and where is it located? Your car or truck headlight switch, also referred to as a headlamp switch, doesn’t just turn the headlights on and off whenever you want to; it has separate components to turn on each of your parking, curb, and/or tail lights as well.
What’s the best way to change an ignition switch?
Reconnect the cable to the negative (-) terminal on the battery, then insert the key into the ignition and turn it to start the vehicle. The vehicle should start without any issue.