Is there a simple explanation for my Peugeot 307?
On my Peugeot 307,I had a wheelbearing replaced.Now the ESP/ASR light is on permanently. Is there a simple explanation? My daughter … read more Vocational, Technical or Tra…
Where is the number plate on a Peugeot 307?
The brand logo became bigger and received a trapezoidal frame, the number plate moved to the lower part of the front bumper of the 307. The top trim levels included chrome elements of the car body, 16-inch alloy wheels and a leather steering wheel.
When did the Peugeot 307 fuse box come out?
The small family car Peugeot 307 was produced from 2002 to 2008. In this article, you will find fuse box diagrams of Peugeot 307 (2002, 2003, 2004, 2005, 2006 and 2007), get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout).
What are the problems with a Peugeot 406?
Peugeot 405 poor/no idle-sorted. 405 Airbag light. Peugeot 406. ECU faulty? Peugeot 106 1997 (P) 1.1 dead!! WHERES A PUG 607 DIAGNOSTIC SOCKET???? Peugeot 106 1.1 R reg HDZ One *FIXED* One to go! airbag reset. Peugeot 406 front fog lamps not working.
Why does my Peugeot 307 have an anti pollution fault?
So if you have the “anti pollution fault” and various electrical faults on your peugeot 307, before you do anything else, get a garage to remove your exhaust from it’s rubber bungs and check the underside, car facing part of your exhaust! Chances are your exhaust is corroded somewhere and it is sucking in air causing the fault!
How is the exhaust system attached to a Peugeot 307?
The peugeot 307 doesn’t have clamps holding the exhaust system up, it is attached to the car via two rubber mounts. Welded rods on the back box push into these mounts. The side facing mount/bung had broken.
How does a Peugeot 307 go into Economy mode?
I drove the car another 130 miles back without a problem, as the car goes into “Economy mode” actaully saving diesel on what it was using with the full suspension attached! The peugeot 307 doesn’t have clamps holding the exhaust system up, it is attached to the car via two rubber mounts. Welded rods on the back box push into these mounts.