How does the maintenance light reset at an oil change?
Turn ignition switch to ON position with engine off. Fully depress and release the accelerator pedal 3 times within 5 seconds of turning key. Change Oil lamp will flash for 2-10 seconds while it resets. Once it stops flashing, the maintenance light reset is complete.
What to do when service engine soon light comes on?
In most cases, you have to repair the problem that caused the service engine light, and it will disappear by itself. If the light shows up because of scheduled service, you need to reset it with a diagnostic scanner or a particular combination for your car model. Can low oil cause service engine soon light?
How to reset the oil soon light on a Chevy Silverado?
Chevy Silverado Truck Change Engine Oil Soon Light Reset Steps: 2011-2015 Display the “Oil Life Remaining” message in the Driver Information Center Press and hold the SET/RESET button on the Driver Information Center for more than 5 seconds (on vehicles without DIC, use the TRIP reset stem for SET/RESET)
How to reset service Engine Soon ( SES ) light?
Press and Hold the Accelerator Place your foot on the accelerator and press it in, but this time, do not release, hold it there for ten seconds. During this step, the SES light will start to flash. 5. Release the Accelerator Release the accelerator pedal after the 10 seconds and see the engine light still blinking. 6. Turn OFF the Ignition
How can you reset the service light?
- but don’t start the engine.
- Press the button on the lower left part of the steering wheel. The display panel will tell you why the vehicle needs servicing.
- Find and press the reset button on the left side of the instrument panel.
How do I Turn Off service engine light?
The service engine light will have turned off. Turn the key in the ignition to “off” and unplug the scanner. Restart the engine and verify that the service engine light is still off on the instrument panel. Turn off the car.
How can you turn the service engine soon light off?
Reset the computer and turn the service engine soon light off by repeating the first process completely, with one exception: When the pedal is lifted after pressing the pedal down for 10 seconds and the codes are flashing, depress the pedal again for an additional 10 seconds and the computer will reset.
How to reset the ‘service’ light?
How to Reset the SES Light Method 1. How to reset the service engine soon light using the Ignition switch and accelerator pedal combination. Method 2. Another way of resetting the service engine light is by disconnecting the car battery. Method 3.