How do you remove a cigarette lighter from a Datsun?
Unscrew the nut with your fingers Headlight switch knob and nut. Removes same way as wiper switch. Cigarette lighter. Reach up from under dash and unscrew the housing (unscrew the collar of the lighter from the back). Then the lighter body pulls straight out of the lid. Pull the L (blue) wire off the cigarette lighter when you can see it.
How do you remove the dash from a Datsun?
There’s live power in the dash assembly, so this is important unbolt glove box: Open glove box door, then remove two tiny bottom screws, and two larger top screws. Leave the the latch bolted in. Pull the box out from behind remove the round clip holding the glove-box door swing arm. Then remove the little plastic rectangle.
How do you remove dashboard from Datsun 1200 Club?
Leave the the latch bolted in. Pull the box out from behind remove the round clip holding the glove-box door swing arm. Then remove the little plastic rectangle. Then set the door in a safe place, it scratches easily Remove the two 12mm-head bolts holding the steering column to the dash assembly.
Which is the correct headlight switch on a Datsun?
65 – 67 Fuel tank sending unit gasket. 67 1/2 – 70 Fuel tank sending unit o-ring. Complete headlight switch with the correct knob and bezel. If you have a single row fuse box in your glove compartment then this is the correct switch.
How much does a Datsun electrical switch cost?
Order by PART# 2235PAD $89.00 This pad supplements the inner “Datsun” plastic center piece. The inner “Datsun” center piece, below the outer pad in the photo, is often cracked and crazed. The replacement part pictured is a “3D” injection molded exact replica of the original that has been painstakingly painted.
Which is the correct switch for a headlight?
Complete headlight switch with the correct knob and bezel. If you have a single row fuse box in your glove compartment then this is the correct switch. Click here ,to view other switch. Complete assembly with the correct knob and Bezel.
What kind of ignition switch does a Datsun Seiki use?
Kanto Seiki and FAE Be sure to install sender and nut with anti-seize lubricant. Comes with original style connector and clear shield. 64 – 67 Brake light switch. Screws into fitting in engine compartment and activated by hydraulic fluid pressure. These are the correctly threaded units. Rear electrical portion of the metal locking ignition switch.