Why do I have p1122 on my Nissan?
Common causes of code P1122 on Nissan applications are many and varied, but could include one or more of the following-. Damaged, burnt, shorted, disconnected, or corroded wiring and/or connectors anywhere in the throttle body’s control signal circuits.
What does the OBD code p1122 stand for?
OBD II fault code P1122 is a manufacturer specific code that is defined by car maker Nissan as “Electric Throttle Control Performance Problem”, and is set when the PCM (Powertrain Control Module) detects an abnormally high or low signal voltage from the electronically controlled throttle actuator.
How to check idle speed on Nissan Pathfinder?
Disconnect throttle position sensor harness connector (brown), then reconnect it within 5 seconds. Wait 20 seconds. Make sure that idle speed is within specifications. If not, the result will be incomplete. In this case, find the cause of the problem by referring to the NOTE below. Rev up the engine two or three times.
When is the p1122 Nissan code detected?
Labor: 1.0 The cost of diagnosing the P1122 NISSAN code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour. When is the P1122 NISSAN code detected? Electric throttle control function does not operate properly.
How to diagnose p1122 throttle position sensor circuit?
Check the “Possible Causes” listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals. The cost of diagnosing the P1122 code is 1.0 hour of labor.
How much does it cost to repair a p1122 code?
Check for damaged components and look for broken, bent, pushed out, or corroded terminals. The cost of diagnosing the P1122 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle’s make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
OBD II fault code P1122 is a manufacturer specific code that is defined by car maker Nissan as “Electric Throttle Control Performance Problem”, and is set when the PCM (Powertrain Control Module) detects an abnormally high or low signal voltage from the electronically controlled throttle actuator.