Can you replace the starter on a Porsche 997?
Here’s how to replace the starter so that something does happen. This article applies to the Porsche 911 997 (2005-2012). It’s a problem that can actually confuse some people. You go to get in your 911 to go for a drive, but when you turn the key, nothing happens.
Is there a problem with my Porsche 997?
This article applies to the Porsche 911 997 (2005-2012). It’s a problem that can actually confuse some people. You go to get in your 911 to go for a drive, but when you turn the key, nothing happens. Most people immediately assume it’s the battery, so they install a new one but still have the same issue.
How to remove throttle body from Porsche 997?
Figure 3. Remove throttle body. After removing the throttle body, you can now gain access to the intake plenum tube which is what the throttle body was connected to. The intake plenum tube is held on by metal clamps and has an air line attached to it that will need to be disconnected also.
How to install chain tensioner on Porsche 911 Carrera?
Now, place the engine at Top Dead Center (TDC) by putting a wrench on the pulley nut and rotating until you line up the Z1 mark on the crankshaft pulley with the seam of the case. Remove the distributor cap, and make sure that the rotor is pointing to the small notch on the distributor housing.
What are the chains on a Porsche 911?
The design of the 911 engine incorporates a dual-cam system that is driven by timing chains connected to the main crankshaft. One of the weak points of the early 911 motors (thru 1983) is the mechanical spring-loaded tensioners that maintain the tightness and accuracy of the chains.
When to replace a Porsche 911 Carrera starter?
This is a possible sign that you should replace your starter motor. However, before replacing your starter, check the condition of your battery and make sure your ground strap is properly installed ( Pelican Technical Article: Porsche 911 Carrera Battery Replacement Trickle Charger Installation ).
Where is the starter located on a Porsche 997?
The starter is located at the back of the engine and is very difficult to see when trying to look in the engine compartment. A fair amount of other components will have to be removed to access it. The starter turns the flywheel of the engine which is how it cranks the engine over in order to start it. This is why it is located where it is.
This article applies to the Porsche 911 997 (2005-2012). It’s a problem that can actually confuse some people. You go to get in your 911 to go for a drive, but when you turn the key, nothing happens. Most people immediately assume it’s the battery, so they install a new one but still have the same issue.
What should I do if my Porsche starter won’t start?
If possible, have the system checked using the Porsche factory scan tools (PST-2 or PIWIS). Once you are certain that the starter is the problem, begin by first disconnecting the battery. You’ll be working around the starter and there is always a 12V load going to the starter.