Where do you mount a taxi meter on a car?
Locate the place on the dash for mounting taxi meter. This should be above the stereo or in the center near the passenger side of the dash board. Secure the mount to the dash attaching the screws with the flat-head screw driver. Raise the hood of the vehicle and locate the speed sensor on the firewall.
How to set the hour number on a taxi meter?
The big display shows the Day number on the left, and the Month number on on the right. The small display shows the Time in Hours and Minutes. Press K1 to set the Day number. Press K2 to set the Month number. Press K3 to set the Hour number (24 hour clock).
How to turn off the F2 taxi meter?
At the end of the trip, the taxi driver has to select the Stopped position using the OP key. other extras to the fare (if enabled). The taxi driver then presses OP to return to For Hire. On the 32 Block F2 and F2 RTC meters the meter can be turned off by pressing the K2 and K4 buttons at the same time.
What are the modes of the taxi meter?
The taximeter has three working modes: For Hire, Hired and Stopped. The taximeter’s working modes are selectable by pressing the OP button in the following sequence: In any of the the above taximeter’s working modes (FOR HIRE, HIRED, STOPPED), the other four keys K1, K2, K3, K4 will exploit a different function, as described below:
How do you put a taxi meter in service?
Run the pulse wire from the meter to the wire at the speed control. Wrap all exposed wires with electrical tape. Place meter in service after it has been calibrated and sealed by a official taxi meter service technician. Most states have regulations which require this to be done. It is then ready for hire.
At the end of the trip, the taxi driver has to select the Stopped position using the OP key. other extras to the fare (if enabled). The taxi driver then presses OP to return to For Hire. On the 32 Block F2 and F2 RTC meters the meter can be turned off by pressing the K2 and K4 buttons at the same time.
How to change year on digitax taxi meter?
Press K1 to increase the Year number. Press K2 to decrease the Year number. Please Note: The ability to set the time and date may have been disabled depending on the setup of the meter.
How to turn off a digitax F2 RTC meter?
On the 32 Block F2 and F2 RTC meters the meter can be turned off by pressing the K2 and K4 buttons at the same time. The only exception to this is on the 4 Block F2 where the K1 button will turn the meter off. The meter can be turned on again by pressing the OP button. Select For Hire position. Press K1 and K3 together.