Why is the airbag light flashing on my Nissan Note?
Please try again later. This 2007 Nissan Note E11 model came in for diagnosis of the Airbag light flashing. It’s an MOT failure item so needed fixing to pass the test. Join me as I diagnose & repair the problem. and subscribe to keep up to date with the latest uploads. This video is for entertainment purposes only. Loading…
How to reset the airbag status light on a Nissan?
Step 1 Insert the key into the ignition and turn the key to ON. Notice that the light will stay on and then start blinking. After turning the key to ON, wait until the light turns to off, to start the blinking process, and then switch the key OFF and remove the key. Wait 5 seconds. Stick the key back in the ignition and repeat step 1.
Why is the airbag status light not blinking?
If you have recently installed a new stereo or removed the seats in your Nissan, you may have noticed the airbag status light will not stop blinking. There is a simple fix for this that will keep you from having to take it to the dealer.
How to reset the airbag light on a Nissan Versa?
Watch the airbag light closely. It will stay on for a few secs. and then as soon as it blinks off (the start of the flashing), turn the key off instantly. 3. Count to 5 (1 Mississippi, 2 Mississippi . . . .) 4. Repeat steps 1-3 two more times until you have done the cycle three times. 5. Now turn the key on and watch the light.
What does it mean when the airbag light is flashing?
A flashing airbag warning light indicates a significant problem with the SRS system meaning you should take it to a repairer immediately. If the light stays on, you should still take it to repairer, however, there are a few things you can try first that could rectify the problem.
Why is my airbag light blinking?
One of the possible and more common reasons to make your airbag light flash is depletion of the battery backup of your airbag. This could be caused by the recent draining of the car battery.
Can I reset airbag warning light?
How to Reset an Airbag’s Warning Light Find the fuse panel cover in the foot well on the driver’s side of the vehicle. Pull down on it to open it. Find a yellow connector inside the fuse panel. Pull out this connector. Insert one end of the paperclip into one terminal of the SRS power connector and insert the other end of the paperclip into the other terminal.
Why does the airbag light stay on?
Light stays on and warning for airbag service on reader board. If the airbag light stays on after it completes it’s “check light” process then there is a fault in the air bag system. It could be anything from a bad sensor (there are 3 of them) to a wire that has become unplugged. This problem should be repaired as soon as possible because…