How do you read the codes on a Nissan Altima?
How to read the engine diagnostic code
- Turn the ignition key to the on position for exactly three seconds.
- Push the accelerator pedal all the way to the floor and release 5 times within 5 seconds.
- Wait exactly seven seconds.
- Push the accelerator pedal all the way to the floor and hold for ten seconds.
How to read engine OBDII Codes without Nissan scan tool?
In this way, all the detected malfunctions are classified by their DTC numbers. The DTC 0000 refers to no malfunction. How to read the engine codes without a Nissan CONSULT or scan tool. (Set ECM in Diagnostic Test Mode II) Confirm that accelerator pedal is fully released, turn ignition switch ON and wait 3 seconds.
Why does my Nissan club not have a code reader?
On to your problem. That is the code that I had when I was running without a cat, and my rear O2 intercept was not working properly. It is one that WILL stay locked in the memory. It can refer to the MAF, but can also be caused by the rear O2 sensor as well.
Where to find Nissan check engine light codes?
These are listed in numerical order for easy searching. When retrieving Nissan check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.
How to check car code without a code reader?
To any and all that might be interested, you can save yourself a trip to the local parts store and check codes at home. Find yourself a watch with a second hand and do the following… —Make sure car has been off for at least 15 minutes. —Wait 7 seconds. The SES light will blink out the code/s that are stored in the memory.
In this way, all the detected malfunctions are classified by their DTC numbers. The DTC 0000 refers to no malfunction. How to read the engine codes without a Nissan CONSULT or scan tool. (Set ECM in Diagnostic Test Mode II) Confirm that accelerator pedal is fully released, turn ignition switch ON and wait 3 seconds.
On to your problem. That is the code that I had when I was running without a cat, and my rear O2 intercept was not working properly. It is one that WILL stay locked in the memory. It can refer to the MAF, but can also be caused by the rear O2 sensor as well.
To any and all that might be interested, you can save yourself a trip to the local parts store and check codes at home. Find yourself a watch with a second hand and do the following… —Make sure car has been off for at least 15 minutes. —Wait 7 seconds. The SES light will blink out the code/s that are stored in the memory.