What is the right of way for a water main?
For water mains to be owned and maintained by the Company, a minimum 30 foot right- of-way, centered over the water main(s), shall be included in the easement transferring ownership of said water main(s) to the Company and obtained by the Contractor/Developer prior to installation of said water main. 6.4 TRENCHING
How to install a water main in Maine?
1.1 The work to be done consists of trenching, laying water main, services, hydrants and other necessary appurtenances, backfilling the trench, and properly completing the work of water main construction at locations called for in accordance with plans approved by and at a time required by The Maine Water Company (hereinafter called the Company).
How to turn on cold water in reverse osmosis system?
Turn on water supply to pressure cold water line. Snug nut/seal with wrench around valve stem. Connect tubing to feed water valve using brass compression nut, stiffener insert and plastic sleeve.
How do you reinstall a water faucet cartridge?
To reinstall the cartridge into your faucet assembly, reverse the steps that you followed to remove the old cartridge. Reinstall the retaining clip, the limit stop and the washer onto the cartridge. Fasten the escutcheon to the wall. Replace the handle adapter, and finally secure the handle using the hex key.
How do you flush solidified water through a toilet?
The solidified water can simply be flushed through the pipes by adding enough water to “overpower” the crystals. The toilet is attached to the floor using two closet bolts and nuts. Use an adjustable wrench to loosen the two nuts at the floor level. You may need to pry off a plastic cap covering the nuts.
What to do if you have a water supply leak?
If you have a supply hose leak, the leak will continuously drip throughout the wash cycle. Here’s how to repair water supply hoses: Turn off the water main or shutoff valve. Unscrew the supply hoses with pliers. Examine the hoses. If they look old and corroded, replace the hoses with no-burst hoses and new washers.
How do you remove water from a toilet?
Flush your toilet and keep the handle down to empty the toilet of water. You’ll be left with some water in the tank and some in the bowl. Use a large sponge and bucket to remove the remaining water in the tank. For under $4, you can purchase a water solidifier. Simply pour the packet of water solidifier into the toilet bowl and wait five minutes.